Search:

Type: Posts; User: Gianelli280

Search: Search took 0.00 seconds; generated 2 minute(s) ago.

  1. Replies
    1
    Views
    784

    2010 Escape tuning questions

    Longtime LS tuner here, so looking at a ford tune is quite different. My brother recently picked up a 2.5L and a 2010 Escape PCM to put in a Ranchero. We've been looking into PATS and just getting...
  2. Replies
    1
    Views
    1,091

    Found this in another post and think it might be...

    Found this in another post and think it might be the answer "...it can't pull timing if both tables are the same." Since both tables are the same for me would this prevent a knock event from pulling...
  3. Replies
    1
    Views
    1,091

    Launch timing control using KR

    Started this thread in the lounge - thinking it might be more appropriate in here. Basically I'm feeding the knock sensor inputs with a pulse generator in order to cut timing on the line after the...
  4. Launch control using induced knock retard

    Moved this thread to GM gen 3
  5. Replies
    1
    Views
    1,045

    Ham-handed 2 step launch control

    Before I go swapping pins in and out til my fingers bleed, someone tell me if this will work... My aim is to limit spark by using a shift solenoid output of the PCM.

    I'm using a th400 so no...
  6. Replies
    8
    Views
    2,170

    Ok, I won't let it hinder progress. The old boy...

    Ok, I won't let it hinder progress. The old boy only drinks premium, though arco is my go to - just filled up with premium at chevron, so I'll keep an eye on it. Seems like I should only really...
  7. Replies
    8
    Views
    2,170

    Sounds good - should I also have PE kick in a...

    Sounds good - should I also have PE kick in a little earlier to avoid the knock?
  8. Replies
    8
    Views
    2,170

    Here's a scan of what I'm seeing. Log and tune...

    Here's a scan of what I'm seeing. Log and tune should be attached.
  9. Replies
    8
    Views
    2,170

    Revisited the VE tune in SD mode, and have...

    Revisited the VE tune in SD mode, and have reworked my table quite a bit - found out STFT's were still enabled during my SD runs which explains the factory model only with 15% more fuel, whoops. ...
  10. Replies
    8
    Views
    2,170

    Very much appreciated - I?ll run through the tune...

    Very much appreciated - I?ll run through the tune over the weekend.
  11. Replies
    8
    Views
    2,170

    Newbie here with some tuning questions

    Did a cam swap and looking for some tuning help - I'll post a pass and my boogered tune, and have a feeling I'm WAY off with the tune because factory cam and tune was quicker in the 1/8.

    Here's...
Results 1 to 11 of 11