Your not seeing it because its not there , looks like its not supported on that OS..
Type: Posts; User: BADWOLF
Your not seeing it because its not there , looks like its not supported on that OS..
[ECM] 12283 - Fuel To Wall Impact Factor vs. Cool Temp vs. MAP:
I think its what your looking for..
.
4.4.2 Advanced view
Do compare of a auto vs manual file for your os , all other things being equal , lots of differences between a flywheel (energy storing) vs a converter (energy stealing)
Looks like the original tune was a manual, made some adjustments..you may have to tweek the BRAF P/N
90469
Edit; The idle max P/N and BRAF alone might get it for you if the other parameters have...
Run it through the Bluecat Trans tool and use 5200 for Desired shift rpm
https://forum.hptuners.com/showthread.php?44953-Bluecat-Transmission-Table-Software
...
Is this what your looking for..?
02 Silverado 4x4 4l60
[ECM] 730 - Starter Diagnostics Master Enable;
as stated in the first reply try setting it to Disabled
Try removing the channels, repoll for supported parameters while connected to the vehicle, then add the channels back in.
When selecting Gauges click the gear icon in the tool bar to show only parameters backed by channels ..
For Battery Volts you can use control module voltage if a PO1/P59.. IIRC...
As for...
Use the Navigator Ctrl+N enter ECT
90309
Try Setting [TCM] 403 - TCC Enable Solenoid: Master enable/disable for the TCC enable solenoid, to Enable
You need to be in Advanced View...
90277
This is on OS 12212156-> RTT Enhanced so i dont know how it will translate to your Commodore OS
[14200] is the channel in the Scanner and is labeled Trans Shift Mode and shows Normal,Power,Cruise...
Try setting P1626 and P1631 to no error reported...
It's [14200] Trans Shift Mode on my po1 ..if that helps
There is also a setting under Trans>shift general for switch type, set to one switch...?