Search:

Type: Posts; User: Cool28

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    10,428

    ya just looked at your file you have the right...

    ya just looked at your file you have the right fuel system but as you guessed numbers all wrong. Put in the ones I post that should get you there or close. Works on mine with a 98 fuel sender and...
  2. Replies
    12
    Views
    10,428

    I never had to change the wiring after swapping...

    I never had to change the wiring after swapping over to the 0411. Have to do a segment swap and mess with the sender range in hptuners. Also make sure that the pin isn't pushing out when you put...
  3. Replies
    8
    Views
    3,661

    Well my map sensor died I think and I don't know...

    Well my map sensor died I think and I don't know but think it screwed up the trans. Map was reading 101 at key off when I checked it. Set a tps code amd lost gears.

    At this point I'm pretty...
  4. Replies
    8
    Views
    3,573

    Ya I had air again in it.. starting to wonder if...

    Ya I had air again in it.. starting to wonder if I have a head gasket going
  5. Replies
    8
    Views
    3,573

    ok so it didn't overheat today cause it's like 70...

    ok so it didn't overheat today cause it's like 70 out but them were

    PCM =217
    thermostat it is 180
    top radiator hose 193
    driver side radiator side 136
    pass side 123


    Things to note the stem...
  6. Replies
    8
    Views
    3,573

    Yep have a temp gun. If I put the temp gun on the...

    Yep have a temp gun. If I put the temp gun on the sensor it matches the temp on the scanner. If I remember right it goes in from the rad at 180 degrees.
  7. Replies
    8
    Views
    3,573

    this is a SD tune so don't really know why the...

    this is a SD tune so don't really know why the maf reading is doing that
  8. Replies
    8
    Views
    3,573

    getting hot at idle but not while driving

    tonight went to get gas and back pulled in the garage and been having this problem with it getting hot. SO I logged some things and ill post the tune file. One thing temp got to about 217 and...
  9. Replies
    8
    Views
    3,661

    heres the file. was going to do a run but I...

    heres the file. was going to do a run but I didn't like how hot the car was getting
  10. Replies
    8
    Views
    3,661

    I'm going to log my trans ouput speed and scanner...

    I'm going to log my trans ouput speed and scanner mph and see if the two jive with the calculation I found surfing the forums. A old screen shot I got shows the trans thinking it's only going 33mph...
  11. Replies
    8
    Views
    3,661

    Haven't quite figured out all the stuff I can...

    Haven't quite figured out all the stuff I can scan yet. Was efilive for a long time
  12. Replies
    8
    Views
    3,661

    What parameters would I set to scan?

    What parameters would I set to scan?
  13. Replies
    8
    Views
    3,661

    The rear is 3.00 and 26.4 tall tire Also if I...

    The rear is 3.00 and 26.4 tall tire

    Also if I write entire will it license the segment that currently say unliscensed? Another programmed this and just haven't did write entire since I thought it...
  14. Replies
    8
    Views
    3,661

    Need some logging help

    I've had this problem for alittle while and thought it was caused by 1-2 clutches beING burn but they been replaced and holding great now.

    Part throttle shifts great. This is a 0411 pcm in a 98...
  15. Replies
    15
    Views
    12,267

    Old thread here but having a issue. I have the...

    Old thread here but having a issue. I have the setpoint for wot to drop to 1st at 45 but when I'm doing 60+ it still wants to downshift to 1st. By using the calculation abov it's showing 33.5mph....
  16. Replies
    1
    Views
    1,335

    Well that wasnt it. Put the value up to 20% and...

    Well that wasnt it. Put the value up to 20% and still does it
  17. Replies
    1
    Views
    1,335

    quick question about PE and fuel trim cell

    Read up on it but I want to get more info since the tune is a Speed Density tune. I have a 0411 pcm with a custom 3 bar program in it. This is running a lq4 408 and f1a at 12psi. When coasting...
  18. new to hp tuners idle cruising with convertor locked

    First off feels great to let off the gas and the convertor not unlock on a 4l80e after like 4 years of driving it that way. The only problem I have with it now it engine brakes pretty good and I'm...
Results 1 to 18 of 21