What?s the strategy?
Type: Posts; User: projectlnf
What?s the strategy?
I highly doubt you can find them anyways unless you knew the exact addresses.
And I?m sure MCC doesn?t show that. That would be a winols deal where you would have to manually find them and build...
Post your file so we can help.
But it sounds like you need to flash a file to it so the TCM knows what it?s supposed to do.
Unsure on this because I have only done a few L5P TCM?s
What do you need user defined parameters for?
That?s for HPtuners only. I think jetskier is saying use MCC program to adjust for the SOTF.
PM me and I?ll help you out. I have tuned a couple of them.
That?s all it says is just Failed?
No x code to the left of the status bar?
If I am not mistaken that is a non inferred strategy.
Easiest way to tell is hook your interface to the truck and open the scanner.
Connect to the vehicle by clicking the little car icon in...
144028
Yes your stock file.. have you done a read on the truck with HpTuners interface?
We can?t guess your strategy code on your ecm.
Post your file
You would think they would but as we all know in the diesel tuning world things are kept so tight knit that they probably won?t tell you.
Be easier to almost guess lol
Jeff is right though you...
No. HPtuners will only pull HPtuners files.
Contact me and I can help you with BIN files but the BIN is only the start of it. Probably the easiest and smallest part of this whole process.
Without the BIN extraction part of it yes. But there is way more to it than that.
You need a Damos or A2L. Those files you pay big money for.
With just a BIN you have a HEX file that has...
My theory: you need fuel to make boost.. so if you cut fuel you loose boost.
If you reduce timing you build boost faster because you get the exhaust hotter. Turbos run off heat and pressure so...
The config for the extra tables probably doesn?t allow it.
Send me your file and I can check to see what config you have running to see if it that?s it.
You set the respected temp to make the total timing -15
-15 is the limit of negative timing you can do without XDF?s as far as I have seen on all of the 6.0.
So after you build your...
Injectors are all in the FICM injector PW 1 (PW 2 is never used, I have never seen it used at least)
The way I do it is reduce PW in the idle up to just below WOT.
Some injectors like a little...
I did a write up in here on the basics (my way)
Being brand new with that big of an injector is going to be a pain unless you get someone to help you with your FICM. I have never tuned anything...
Pm me the file
PM me with your problems and I might be able to help
Sounds to me like the tooner done messed up!!
PM me I might be able to help.
Do a log of it happening.
Log as many channels as you can that pertain to the engine/fuel
What djv86 said.
Without the XDF/UDP files you?re dead in the water man! Been there done that!
Post your file.
I might be able to turn on the cycling.
Send me your file.
You will more than likely have to pay another licensing fee (I did when I did mine)