Maybe we are both in the same boat.
I checked my connection and the wires dont seem burned by ypipe or pinched .
Was yours the stock old O2 sensor that came with donor vehicle or did you buy a...
Type: Posts; User: SaskCutlass
Maybe we are both in the same boat.
I checked my connection and the wires dont seem burned by ypipe or pinched .
Was yours the stock old O2 sensor that came with donor vehicle or did you buy a...
Sounds pretty thorough BUT I believe the harness grounds are most important.
On my LS block i have 3 harness grounds to the block, a ground near temp sensor to block and 2 grounds to the block on...
im getting a P0154 code=O2 sensor circuit no activity detected
someone esle said check your grounds
ive got same pcm and have had issues with fans too. I was using a 3 wire temp sensor to try enable aftermarket temp gauges but neither of them read proper temps so i put a new 2 wire back i
not...
in my PCM
under A/C look for a fan recirc setting
if this is disabled , you can use fan 2, if its enabled the pin out for fan 2 gets used for ac fan recirc
it may be same/similar for you
How does a guy do this evap delete? just turn off the DTC in the pcm [or is that similar to just erasing codes with a scanner and they willre-occur]
Do i need to actually disable some evap setting?
What does a guy do when swapping that same 5.3 into 84 G-body with no evap system?
im getting 3-4 evap codes that recur as soon as i drive it.
My car runs quite well but i suspect its running very...
ive been poking around those tranny settings. are you saying disable abuse mode OR max out the % , whichever basically stops that mode from working or were you saying change 2 different settings?...
im curious too
Hey Joe, I cant help youbut i am in same boat wondering about TQ management.
whats the details of your swap?