Search:

Type: Posts; User: davkenrem

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    1,176

    I will double check it.

    I will double check it.
  2. Replies
    7
    Views
    1,176

    460LE Overheating after a 0411 PCM Swap I ran...

    460LE Overheating after a 0411 PCM Swap
    I ran accross you post while for help on my issue, they sound similar.


    I have a 1997 Chevy K1500 Suburban, with a new L31-R Crate engine and rebuilt...
  3. Replies
    11
    Views
    377

    Sorry I havent replied, truck was down for a week...

    Sorry I havent replied, truck was down for a week or so. Had to chnage ball joints and front axle shafts. Got it back together of thrusday. Will getting logs today.
  4. Replies
    11
    Views
    377

    Yes, on the tire and gear ratio. And I agree on...

    Yes, on the tire and gear ratio. And I agree on the shift points but wasn't sure what should adjust them to? Any suggestions?
  5. Replies
    11
    Views
    377

    I will run these this afternoon and report back.

    I will run these this afternoon and report back.
  6. Replies
    11
    Views
    377

    Drove today about 20 minutes. Trans fluid temp in...

    Drove today about 20 minutes. Trans fluid temp in the log rose to 189degrees. Checked the lines at the radiator and temp was 101-103degrees on both lines. Checked at lines going into tranny, temp was...
  7. Replies
    11
    Views
    377

    I will check that tomorrow and get back with it.

    I will check that tomorrow and get back with it.
  8. Replies
    11
    Views
    377

    I was finally able to duplicate the issue. Sunday...

    I was finally able to duplicate the issue. Sunday morning driving to destination I experienced the issue again. Looking at the log file and noticed trans fluid temp got to 249 degrees.

    Something...
  9. Replies
    11
    Views
    377

    Anyone, anyone at all? Bueller??

    Anyone, anyone at all? Bueller??
  10. Replies
    11
    Views
    377

    Trans issue after 0411 PCM Swap

    I have a 1997 Chevy K1500 Suburban, with a new L31-R Crate engine and rebuilt 4l60e. I did a 0411 PCM Swap to add efans and tune for the cam and headers. I used a 0411 PCM from a 2002 GMC Savana 2500...
  11. Replies
    4
    Views
    444

    Wow, what a difference, I went through and...

    Wow, what a difference, I went through and rechecked all my pins. Had two in the wrong spot, one in a not used location and the other which was for the trans line pressure in the wrong place.
    ...
  12. Replies
    4
    Views
    444

    Got the PCM in today with no missed wires. Truck...

    Got the PCM in today with no missed wires. Truck fired right up. Running rough, need to adjust idle. Drove it around the block and trans did not shift right. Not sure if it was because I had not yet...
  13. Replies
    4
    Views
    444

    Thank you for the reply, This is the CAM I'm ...

    Thank you for the reply,
    This is the CAM I'm running. https://www.summitracing.com/parts/NAL-12677151
    Idle is a little low.
    I'm going to put the computer in this Saturday and I will report back....
  14. Replies
    4
    Views
    444

    0411 PCM SWAP Questions

    Hello, all Newbie to PCM Progamming With some questions.

    I have a 1997 Chevy Suburban K1500 with a new L31R Crate engine in it. I installed the Chevrolet Performance Hydraulic Roller Camshafts...
Results 1 to 14 of 14