Search:

I am able to read an 01 Yukon fine but it says "write transfer timed out" every time I try to flash it. Anyone run into this?

Any help would be greatly appreciated. Tuned an ls2 speed density in a Nova and the tune went normal, ran perfect and made good power. The next day I went to start it and it sounded like a...

I have, it appears as though I am only having issues with what might have been cars tuned with 2.24. I have one on the dyno now

I was hoping there was a newer version that fixed all the issues I am having :-)

I am in the same boat and dead in the water right now with cars in the shop..any file i click on is asking me to purchase credits..files were sent to support already

I just updated again because of all the issues I am having and it only set me up to 3.0.18

When I updated to 3.0 I lost 2.25 and 2.24 and I cannot load any file or make any adjustments on cars in the shop without being asked to buy more credits? Any ideas?

It's a fully built MAST motor

No sir

LS7 swapped, rev limiter set to 7400 and speed limiters etc is shut off..no matter what I do it won't rev past 7k? any ideas?

Hello,
I am looking for a file to do a segment swap in. the ecu used in a customers car is setup for a 4l80 and he is running a 4l60. Any help would be appreciated. the os is 12614088

Found one

Found one

Hello Russ K, You wouldn't happen t have one for a 12579405 4l80 would you?

Ive never done a segment swap before and would appreciate any help, where do I go to get a file to segment swap from? I am converting an 03 Silverado from a 4L60 to a 4L80. 12579405 OS

LunTec, Raise your Wheel Tq Error Max.

Any chance I could get a copy of the ERod/Auto stock file? I am working on an E67/T43 and the previous tune is from Edelbrock (SCT) and I can't read it without errors.

I figured it out

With the scanner I am getting an "Unable to create a log" error and with editor I am getting "ECM Definition failed to load. You will be unable to edit this file" I emailed support twice but no...

I did with no response

I recently bought a new computer that has windows 8. I loaded the latest version of editor and scanner and loaded the windows 8 drivers. Device manager recognizes the mv when it is plugged in, when I...