It did allow me open and write file. Still same no speedo.
Guy from novak finally called back. Told me call GM performance. Thinks the controller only work for E67 & E92 controlers.
Type: Posts; User: 06TrailblazerSS
It did allow me open and write file. Still same no speedo.
Guy from novak finally called back. Told me call GM performance. Thinks the controller only work for E67 & E92 controlers.
Changed back to .CPM
Get error "This file does not match the correct format foor use with this software" when try opening the file with trans software.
Sure thing.
Thanks I'll give it try
130255
Maybe?
Have be changed back to cpm to open?
I am using usb to tcm using gm performance software.
Tried and must be doing something wrong. Cant seem figure out how change file type to upload.
I must be doing something wrong. It want let me change the file to different type when saving file so could upload.
Tried multiple times and manage attachments says cpm.file is invalid
I've had it programmed as manual and wires are hardwired to the ECM. ECM shows vehicle speed in pid.
Calculated wheel speed in ECM or TCM software. Going go look at both.
Check make sure cam sensor is wired correctly. I had same problem few months back. Wiring harness builder had cam, maf and something else wrong.
It has factory 2008 LS3 controller and harness built by novak. Has novak performance 4L60E level 3 with adaptor. The tech department at novak saidd this combo would work before ordered trans &...
Another odd thing.
The TCM doesn't show. Can't do read with HP tunes. But when use my snap-on scanner as 2008 chevy express van with 5.3L the scanner comms correctly.
NOTE: These transmission controller kits only function in conjunction with CPP EROD/LS Engine Controller Kits. You must
ensure the Vehicle Speed Sensor connector from the engine harness has been...
The VSS is directly connected to the ECM (X1 connector pins 71&72). Thats why I'm at loss. The ECM displays MPH in scanner, but trans controller doesn't show MPH.
I'm going loo back over the...
So what am I missing?
This is what I see in the instructions.
NOTE: These transmission controller kits only function in conjunction with CPP EROD/LS Engine Controller Kits. You must
ensure the Vehicle Speed Sensor...
Build has 2008 Vette LS3 and aftermarket performance transmission with GM performance 19302409 controller & harness. The Can lines have been connected between modules. The transmission module shows...
Can the fuel tank capacity be changed and it function correctly? I'm looking at ordering 66 or 68 gallon tank for my truck. But before spend 1K to be able program the truck. Can be done?
Had speartech make harness for 66 chevelle that i swapped ls3/6speed auto that was perfect out of the box. They had few options for shift indicator, cruise control ( and switch for older gm column)....
You was right the cam sensor was wired worng. Also found the MAF sensor wired wrong. Both connectors was wired backwards.
Thanks everyone for help. Now got figure out none functioning cooling...
I was manual trans. I have performance built 4L60E installed with GM performance TCM controler. I have not yet done the TCM program setup.
I did full write.
No codes currenty setting. I did have repin the APP sensor do having signal returns wires switched.
I'll check the cam sensor wires.
Have stock 2008 Vette LS3 E38 with standalone harness built by novak in CJ7. No spark or injector pulse. Think it's in theftlock, but scanner data doesn't show it's active. Can perform injector...
Thanks for the reply.
The 4.3L was never offered with manual trans. In the Tune guy set it up without spped sensor. I've since changed tune to have vss. Know name of the company sells module?
NV 4500 trans.