Search:

That had worked, no more limp at part throttle, thanks

Enable map on the other hand is causing a really bad throttle hang over 4K rpm for about 1-2 second,
Had to shut down ignition at the end of...

Same tune without boost (belt off) doesn’t cause any problem at part throttle

Hi

I have been chasing a problem on my Magnum for a long time and I cant pin point the problem,

car goes in Limp at part throttle when going in low boost cruising on the high way mainly on...

Lilsick that did the trick !
Car run perfectly now

Big thanks to you !

Hi

I am having simple trouble but cant find the correct adjustment for this problem

once the car starts moving, throttle open by itself causing the car to slowly accelerate
also making hard to...

Hi

Going from a 2 bar to a 3 MAP sensor because I will go with higher boost and Would like to have more adjustability of tuning fuel table on different load.

Can someone explain to me how to do...

Hi

I managed to correct the calculated torque in the tune, I now see about 850Nm at Shift, This have solve 1 of the problem of shifting too low, So now it shifted close of my shift point, but...

Hi guys
Car scedule to be on dyno this wednesday, I will really appreciate to get the information before strapping the car to not loose my session time.

Thanks

Hi

I am chasing a Transmission shift command problem that occur only when the Transmission Engine torque is over 1000Nm, If in some log, I stay under 1000Nm Exemple 996Nm That I got some time for...

Hi

This May be a dumb questions but here it is.

What Is the differance betwen Write calibration or Entire ?

My understanding is If I modyfy a tune that is already in the car, I can Just...

I
Thanks for the information, it makes sens

I will try on my next time to track to unlock the TC, not really shure how to do it, It alwais show APPLY but alwais slip like yours.

Here the only...

problem is not in the transmission and not in the Valve body.

Already had change those 3 time3?s without no change at all.

I beleive there is somthing between the ECM and TCM that create the...

108574
Attached log

Hi

This is a very long issu I have over few years and I was never able to fix it,
Up to now, tried 3 differant Builded transmission, 2 TCM, rebuilded Torque converter Try to remote tune over 50...

same issue here, just put a brand new builded trans and still 3-4 flare, over 50 differant tune and 3 transmission Nag1 I am at the edge to give up !

Let me know If you found somthing, I have a...

Is per What I read, Not recommanded but should be good !
I know If connected to an inverter from your car that you tune it is a No No,
I Use an external battery that is connected to my PC power...

Any one ?

3 days, no reply, Problem is anoying since I cannot log at the track because I do not internet to Resync !

Hi

I am having this issue since the last windows 10 update, I need to resync every time I am using any VCM suite, And it top of that, I need to do it like 20 time each vcm since if fail...

Figure it out with a google search that provide me the correct excel sheet.

Same situation here, Need to hook up an Autometer wideband with a 0-4v with a HPTpro.

Spend the last 4 hours looking for info but nothing for the 0-4volt gauge