Another nice thing that I've seen done is removing Autoride from vehicles....
Type: Posts; User: Jonota
Another nice thing that I've seen done is removing Autoride from vehicles....
I had the same problem as above, got a code 39 and a message saying the driver was missing or corrupt. I made sure that I deleted the .zip folder, and also downloaded/installed the CDM file. Works...
Found some other posts about the TP check found in the Diagnostics. Setting it to Max Kpa 100 and Min Kpa 0 solved my problem completely...
Jonota
Bill, did you ever get any resolution on this problem? Long time ago.... BUT, I'm having the same problem on a 98Z. Stock trans and converter, 3.42 rear, head/cammed engine. When I punch it from a...
I am adjusting the equation on the end. Initial equation same as HPT "stock" AFR=(V/.5)+10
I am already in open loop, but idle for instance bounces around upper 13's and lower 14's . I haven't...
I adjusted RAF by over 2 g/sec, and it didn't change the rising falling one bit. I'm thinking that my VE table is off by too much around the idle areas and that might be giving it a hard time with a...
Russ... I've seen you post several times with your idle tunes spark @40 degrees. As my idle was steady but rough, I decided to try out the spark tables that you posted for Lankness. It made the...
I can't seem to get the AFR to stay stable enough to actually SEE the difference between the wideband output and the HPT reading... I tried to adjust and no matter what I did it seemed that the HPT...
I think that the back of the gauge's adjustment knob is goobered up, so I don't want to mess with hit... I can do EQ ratio, the number in HPtuners seems to dance with it so I think it's close enough...
Think it was a combination of three things:
-not resetting fuel trims, didn't even think about that one
-not getting enough data
-not having the AFR% histogram
Just went for some logging runs...
Checked it, it was in P4 vice the "default" of P0 (out of the box). It was interesting to note however, that in P0 I get 0-5v output on the analog wire, but lambda on the meter, instead of AFR.......
I didn't think to reset fuel trims, so I'll need to do that....
When I looked at the AFR % error histogram it had one box with no axis labels, and it had a number 0 in it. Didn't think I could...
I've read all of the posts and the stickies that I can find about tuning in the above methods. Running a 231/237 .595/.598 in a stock short block, p&p heads (330/280 @.6). My problems is that after...
Having a problem with my UEGO vs HPT that the offset isn't working:
The UEGO seems to track with how the car is running, but the HPT readout only seems to cycle between 10.3 and 12.3, no higher......