Search:

with a 2002 ECU you can utilize real time tuning, removed a 98 ecm and installed a 02 with SLP harness for a 2002 LS1, they make parts for swaps, but the engine harness is abou 800 bucks. I would...

Anyone know a way to set a default offset to bring those numbers down and manipulate the ecm, Any suggestions?:cheers:

Even with 2 bar map applied, and with 2 bar map chosen on scanner, no reading, then w/ normal map, read but wil not go past 105kpa. :banghead:

if ya want i can dig it up:cheers: :cheers:

Thanks WS6!!

:secret: :banghead: Is there an advantage to this? anyone know if it was done for the "E" word (emissions), performance or a smoother idle??:secret: :banghead:

:confused: is this ok or do I have a problem?

Thanks Bill, but no MAF, speed density, that tab is blank, Is that normal?

:worship: New to CTP racing and HP tuners, could anyone tell me what affects WOT performance the most, I am starting of W/a built LS1 w/ a 2-bar setup, starting from square 1. Any advice for the...

Any info on if i can tune my 01 Dodge trans with a Cmmins in front of it?:shrug::drivin:

:hi:

Sorry to hear. Best of luck! hope ya find 'em and leave them with a memory of who not 2 steal from!!!!

Consistent Voltage to ECM is essential while reading or writing, heard inconsistent volts while reading/writing could damage ECM. good luck! or make sure your laptop is fully charged also. hope this...

What tuning is not stock, and what did you change when you started having this problem, Could you MAF need to be cleaned? Try cleaning it w MAF cleaner, make sure you unplug it for cleaning, I would...

I noticed also in your log that your TPS is never below 30%, are you having idle problems also?

Your main VE is very spiky, I also noticed you 1bar MAF is converted, but not applied. Some advice on these findings would be greatly appreciated from a senior tuner. Good luck TA!

I tried to open the tune and downloaded it, says can't open because tune is locked. Anyone else having same prob?

I checked out your log and that is very interesting, I would like to see your tune also-good luck!!

Thanks Scott!!

Anyone know if I will get 100% performance w\ 12 volts? and no less.

It is a Mustang Dyno (not the car), controlled via computer, very advanced

Sorry, 2 or 1 WD

24/7, well, almost 8-5 mon-fri, having a FREEEEEE dyno day on 5/31, call to sign in 530-888-8862. Space is limited

Any small tid bit of info on preparing a car (98modLS1,02 ECM) for a drag race only tune? Still experimenting, lookin' for the tenth.

HP Tuner Brethren are invited to represent at Dyno Day. We will have free Dyno pulls,food,drinks,Dyno Day parts discounts and an opportunity to show off what your vehicle can do. Dyno Day is from 9am...