Hello,
is it already possible to use the Corvette PDR in race render
br
Heinz
Type: Posts; User: atlhesi
Hello,
is it already possible to use the Corvette PDR in race render
br
Heinz
Hello,
already possible to tune an euro Fiesta ST?
Hello,
I have logged a strange control of the short term fuel trims during wot.
The short term fuel trims (but just of Bank1) were still working.
Any idea for this strange behavoir ?
Hi,
the lean spike on first to second gear change is from the rpm limiter,
I had to reprogram the trans.
When I log the acceleration with the G-Tech meter,then I can see
a big drop in the...
Hi,
whitch parameters shold I log additionally to find the problem for my timing ?
many thanks
Heinz
Hello,
thanks for your information.
psl find enclosed my tune and log.
many thanks
Heinz
Hello,
my timing drops sometimes in the 3rd gear.
No knock, no torque reduction.
Corvette C5 with Vortech at 7psi.
Does anybody have an idea why ?
I run AFR at appr. 10. How much is...
Hello,
my 98 PCM is dead. I have from a wecked 1999 C5 a PCM.
The 99 PCM should be better for tuning with HP-tuners.
The swap is not easy and requires rewireing of the PCM connector.
Does...
Hello Eagle,
thank you for your input,
The green light at the HP box does come on.
On the C5 information display there are a lot of fault messages appearing.
I diconnectet the battery more...
Hello,
I put by mistake a tune ( only calibration ) form a 98 C5
to antother 98 C5.
Now the car does not start.
And it is also not possible to reload the original tune to
the C5, because...
Hello,
I usually work with HP tuners on Corvette C5.
It works great. But yesteday I tryed to connect to a C6
and my HP Tuners interface does not work.
There is no green light at the interface...
Hi,
Mir gehts gut ! Thank you,
Thanks also for your input. COT is still enabled.
I hope I do not destroy the Dynnatech sport cats
when disable COT.
I guess then cot is also responsible...
Hello,
I am trying to tune my C5 with an Innovate Sensor.
My mods are VaraRam, Dynatech Long Tubes, BBK Throttle body.
I configured the PE table for an AFR 12,9 in low RPM, 12,5 in the middle...