Search:

Type: Posts; User: 1bh

Page 1 of 2 1 2

Search: Search took 0.00 seconds; generated 35 minute(s) ago.

  1. Replies
    3
    Views
    983

    Also check rationality values under engine...

    Also check rationality values under engine diagnosis
  2. Replies
    80
    Views
    57,503

    I?ve read some of your post concerning NN and VVT...

    I?ve read some of your post concerning NN and VVT and you stated that it?s primarily used for emissions. On the modern hemi?s have so seen much gains playing with the VVT. I believe they are around...
  3. A true sensor is always better than being...

    A true sensor is always better than being inferred but how is the sensor being installed ?
  4. Replies
    45
    Views
    16,905

    Transbrake would be nice. Ford guys get all the...

    Transbrake would be nice. Ford guys get all the fun with the new 10 speed. Currently have a twin turbo hellcat and this would definitely make it easier to build boost and not push through the brakes....
  5. Thread: Knock...Why

    by 1bh
    Replies
    3
    Views
    1,113

    Check that your cats aren?t clogged and choking...

    Check that your cats aren?t clogged and choking motor.
  6. Replies
    6
    Views
    2,283

    Are you on e85? The data woundnt be plug and...

    Are you on e85? The data woundnt be plug and play. Just build a histogram and adjust as necessary. Only difference I?d the dead times between x and x2. Takes 30 min to adjust injectors.
  7. Replies
    1
    Views
    1,604

    The Hellcat blower is very noisy and shows plenty...

    The Hellcat blower is very noisy and shows plenty of activity especially around 4-5k area (at least in my car) Both tunes should show knock sensor voltage regardless of tuning aspect.
  8. Replies
    4
    Views
    2,580

    The Afr shown is based on an e10-15 blend. If you...

    The Afr shown is based on an e10-15 blend. If you install a wideband (14.7 cal) it would read correctly. Lambda is still 1
  9. Replies
    26
    Views
    9,417

    Excuse my ignorance but why would a billet crank...

    Excuse my ignorance but why would a billet crank be different than a forged one?
  10. Thread: Transbrake

    by 1bh
    Replies
    1
    Views
    1,719

    Transbrake

    Are you guys working on a transbrake option for Hellcat’s like the mustang 10 speed offering?
  11. Replies
    5
    Views
    1,986

    What fuel? Injectors ?

    What fuel? Injectors ?
  12. Replies
    11
    Views
    3,375

    Any way to reduce boost in first gear. Not sure...

    Any way to reduce boost in first gear. Not sure if you have any electronics for those turbos
  13. Replies
    8
    Views
    2,518

    15psi on that stroker and hellcat blower with...

    15psi on that stroker and hellcat blower with those pullies is correct.
  14. Check your map sensor rationality values.

    Check your map sensor rationality values.
  15. Mike, What ended up being the fix for this...

    Mike,

    What ended up being the fix for this code?
  16. Thread: New to Dodge

    by 1bh
    Replies
    4
    Views
    1,860

    From my understanding HPtuners doesn?t allow...

    From my understanding HPtuners doesn?t allow deleting these codes on the diesels. Many are using a separate programmer to deactivate the codes and then use hptuners for the normal stuff. Dunno
  17. Replies
    17
    Views
    4,607

    It?s the fore system. I have to prime my pump...

    It?s the fore system. I have to prime my pump after an extended off period.

    Try to place vehicle into run position two times before starting and then fire it up.
  18. Replies
    11
    Views
    6,582

    You ever get it to read past 52% ?

    You ever get it to read past 52% ?
  19. Change o2 sensors and see if it corrects.

    Change o2 sensors and see if it corrects.
  20. Replies
    11
    Views
    6,582

    You ever figure this out?

    You ever figure this out?
  21. Replies
    6
    Views
    4,304

    https://www.hptuners.com/forum/showthread.php?4766...

    https://www.hptuners.com/forum/showthread.php?47669-Convert-Diablo-CMR-Tune-to-HP-Tuner&highlight=diablo
  22. Replies
    12
    Views
    4,842

    Basically received a new file from another tuner...

    Basically received a new file from another tuner and seemed to work fine. I looked at the TQ settings and there’s more items enabled with the new tune. Dunno I’m definitely not a tuner but learned a...
  23. Replies
    12
    Views
    4,842

    Well got a new file from a different tuner and...

    Well got a new file from a different tuner and issue went away. Not sure what the fix was but its fixed. Thanks
  24. Replies
    12
    Views
    4,842

    I know it’s crazy. I’m going to call Bill and see...

    I know it’s crazy. I’m going to call Bill and see if there’s something i’m Missing.

    Anyone know what’s pids might help solve this mystery? Is there a maximum amount of channels I can log before I...
  25. Replies
    12
    Views
    4,842

    Well the issue came back. The issue is...

    Well the issue came back. The issue is intermittent which is a pain. I did have a code that popped up that was p00ea which shows up as the temp/pressure sensor but was told it was possibly a TQ...
Results 1 to 25 of 41
Page 1 of 2 1 2