Hp Tuners sent me a file this morning!
I did not expect it to work for some reason. Now i can get it set up finally.
Type: Posts; User: Batwood
Hp Tuners sent me a file this morning!
I did not expect it to work for some reason. Now i can get it set up finally.
2011 F250 truck i just did a complete 2015 engine/ turbo/ fuel system swap. 2011 harness.
HP tuners gives me checksum error when I try to read the file from my truck.
Can anybody help me out with...
I guess I decided to just unhook the green plug on HPT when I'm not using it.
New problem: One AEM controller reads considerably leaner than the other. I even swapped them from left to right...
Sorry for the long post. My HP Tuners connection appears to be messing up my wideband outputs.
I have 2 AEM inline wideband controllers (30-0310).
Hooked into HP Tuners Pro.
Brown Wire On Pin 5...
Hey guys, I've got a rather unique situation on my hands. I'm just trying to see if there's an easy fix.
I have a 2006 Chevy Equinox 3.4 AWD. It had an engine installed from a 2008 Equinox 3.4....
Hey guys, quick question.
I have a German built 2011 Regal T.
I haven't yet purchased credits for the car... hopefully the German version has the same PCM and tune.
Can you throw a GS tune on...
It looks like ?Ryans? Guide is a pretty good start. We have no pyro gauge or anything fancy... not really concerned about stressing the truck to the limit or anything. Just want a little more power...
I was looking around on the repository for a decent towing tune for a stock truck. I found a couple that might be close, but most were for trucks with an intake/exhaust at least.
The truck is an 05...
Nevermind.
It wasn't exactly a tuning question, but I got the situation figured out, I think.
Thanks.
Russ K!
I tried PM'ing you but your inbox is full.
I need some help with something, if you wouldn't mind....
My email is: [email protected]
If you do mind... thats fine too!
I've been talking to Dave from TEP quite a bit...
I will start by just changing the gear ratio settings...
No.... I will start by somehow getting my car to actually MOVE and figure out what...
I read your thread... I'm pretty sure I know what to do know.
ZZP set up my tune in the first place.
I'm pretty sure I have a broken input shaft... it was a 4340 ZZP Shaft.
Input and Output...
I've been reading some threads about changing pcm settings to work with 3.29 gears.
I just had a bunch of race parts put in the trans along with 3.29 gears and 7/8 chain. When I got it back there...
Yea.. .. Updated the firmware with the newest 2.2? 2.22?
Whatever the new release was.
Now it seems to work fine... YAY! :D
Well, I've used both the scanner and tuner quite a few times now, but I put the car away for a couple weeks cause it was snowing out.
Today, I got the car and laptop out, hooked up the tuner, and...