The address is www.performancetrends.com and I think it is the wideband
manufacturer for AEM.
Type: Posts; User: gzero
The address is www.performancetrends.com and I think it is the wideband
manufacturer for AEM.
Hey Chris, just was wonderinng if this new sensor setup would integrate
into the V1.6? It says it has outputs from 0-1v for narrow band operation
which makes it very accurate in that mode? Would...
Thanks for the imput.
You said that if I bought the 2bar upgrade it would cost $299 for the license. What if I wait for the 2.0 release and 3bar map, what cost diff
will there be? Or will there be a difference in the two...
The reason for asking is FJO has an injector driver box with 4 channels
which converts a saturated injector signal to peak hold signal 4amps switch and 1 amp hold. This I figure would make it...
Does any body know if the 2002 vettes are Bank to bank or sequential
fuel injection?
Thanks chris
Is the speedometer memory in the ecu? If so what happens if you replace the ecu and need to match the mileage, can you?
Approx when will the release be for the 2bar?
Will the wideband grapg in the scanner data logging, or just the histogram?
Thx Ralph
Can I use the histogram for this? Or maybe a nother method from logging? Thx Ralph This stuff is cool!!
I have a boosted motor and was wondering about the scaling on the map.
Across the top is RPM and down the side is G/cyl like 0-120. My questuin is how does 0-120g/cyl corolate to vacume to boost? Is...
I dontknow why either. I have chased this and tried all kinds of things wiyh no luck and then just went thru all the setups and found anything different in that area of rpms that was different. It...
Mine was surging @ 2000 -2800 rpms and finally found the table in the Engine retard section under Burst Knock. In that rpm area the retard was higher than the rest so I changed it to alower value to...