Didn't TheTuningSchool used to offer hellcat tuning lessons? I can't find it anymore. Any other places to learn how to tune hellcats?
Type: Posts; User: who-dat
Didn't TheTuningSchool used to offer hellcat tuning lessons? I can't find it anymore. Any other places to learn how to tune hellcats?
cracker/follower is usually when you stab throttle and then it dies. sounds you just need to add more air
With an L99 (Auto) Is it possible to set the tune to have DoD on in normal mode and DoD off in sport mode? Been thinking of ideas, but can't figure anything out
I had the exact same problem. Didn't check your tune or log, but symptoms were same as me. 2011 camaro here
Fix : Idle-Airflow-Airflow Final Min - increase by 2g/s until no longer stalls at your...
I downloaded the newest BETA, however this did not solve the issue of half my channels missing in the standalone datalogging. Issue looks the same as OP. What can I try to do to fix this?
Did the reset and preset, and drove about 20 miles since doing that last. Shifts are more normal to how I have it set up in the tune. It still seems a tad bit slower, but I feel like after some more...
I drove it about 10 miles so far, but I'll put a good bit on it tomorrow
I had my car in park, idling, and decided to see what these functions do.
I hit trans adapt reset, then i hit trans adapt preset, and then I hit Fast Learn.
The car increased idle by 250rpms...
I've been trying to get my transmission to shift at WOT based off 6400 RPM.
I've set WOT shift speeds from 1-2, 2-3, 3-4 to 0.
I then set WOT RPM to 6400 1-2, 2-3, 3-4.
It completely...
bump
Does anyone have a basic (Intake/exhaust) tune for a 2011-14 Mustang 5.0 finished they wouldn't mind uploading so I can compare my first Ford tune to it?
I installed 3.91 gears into a 2011 Camaro.
Do I update Ratio & Trans to the new gears or just Ratio?
Do I need to change Ratio - Error?
Thanks
Reviving this old thread - Did you ever find the solution?
Gotcha. Thanks for the info
Any idea why I am unable to select "Last Values" in my graph?
Was able to view this, but only by going to Graph Layouts and selecting through View
Finally got it reading somewhat accurate after calibrating it literally 3 times. It's reading 14.6 - 15.1 at idle now. Lots of fast fluctuation. Same thing is happening during part throttle/cruising...
I doubt the sensor is already bad as it's only been installed 3 days now. Maybe it's not far enough in the pipe?
I have no gauge hooked up at the moment.
I have the analog 1 wire connected directly to the side of the pro suite.
Posted this in the wrong forum to begin with, so sorry for 2x post.
I am using an LC-2 wideband. I have it calibrated, have it programmed to default voltage, and now trying to get it to read...
I do not know why I am having so much trouble.
I am using an LC-2 wideband. I have it calibrated, have it programmed to default voltage, and now trying to get it to read properly in HPT. It's...
Finally got them working.
I had to do an 83 mile drive cycle before they'd reset. Stubborn computer...
2012 mustang 5.0
What are a few reasons that I can not get the LTFTs to read at all in the scanner?
Do not have the log or file with me atm.
LTFTs are enabled. o2 sensors are working....