Search:

Type: Posts; User: Ben Charles

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Flash engine back to stock and see what it does!!...

    Flash engine back to stock and see what it does!! Without TCM being modded, engine can somewhat control the trans side, but not what you are experiencing..

    Very odd
  2. Replies
    8
    Views
    67

    Correct... I converted wrong, dumb moment!! Yes...

    Correct... I converted wrong, dumb moment!! Yes you have plenty of room..

    I have cam cars that move more air then that, is the tune scaled??
  3. Replies
    8
    Views
    67

    You’re thinking idle speeds Bc that’s around 7.5...

    You’re thinking idle speeds Bc that’s around 7.5 g/sec which is about right for idle airflow..

    I want to know how much it’s moving at WOT
  4. Replies
    8
    Views
    67

    What G/sec are you at, at 10k hz?

    What G/sec are you at, at 10k hz?
  5. What’s the vehicle?? Have same issues with 18 Zl1

    What’s the vehicle?? Have same issues with 18 Zl1
  6. Replies
    5
    Views
    176

    Buy Hp tuners, worst case get someone here from...

    Buy Hp tuners, worst case get someone here from the boards to help you
  7. Yep! Add slave and max it out

    Yep! Add slave and max it out
  8. Replies
    20
    Views
    625

    Pop and cracks on decel is mainly lower spark in...

    Pop and cracks on decel is mainly lower spark in that region... simple
  9. Replies
    3
    Views
    99

    Yes

    Yes
  10. So target near stoich in the mid to low boost...

    So target near stoich in the mid to low boost region of PE
  11. Hit the same fuel but Target less... this will...

    Hit the same fuel but Target less... this will keep Tq model correct and if automatic trans, much happier since will be reporting correct Tq and not several hundred Ftlbs less then it should
  12. Replies
    11
    Views
    308

    For what it’s worth I’m not able to make 17-18...

    For what it’s worth I’m not able to make 17-18 trucks (6.2) to stay in Open loop no matter what I set things too.. haven’t tried 5.3
  13. Replies
    15
    Views
    453

    Most likely fuel off and or timing too agressive

    Most likely fuel off and or timing too agressive
  14. You can do pure PI... From what I’ve seen the...

    You can do pure PI...
    From what I’ve seen the “cup” in the piston isn’t needed
  15. Replies
    14
    Views
    688

    Just drive it and in about 10 minutes it goes...

    Just drive it and in about 10 minutes it goes back to normal temp
  16. What’s the specs? I may be able to help

    What’s the specs? I may be able to help
  17. Replies
    8
    Views
    304

    Sounds like you have an issue with fuel..

    Sounds like you have an issue with fuel..
  18. Replies
    7
    Views
    290

    I didn’t look at the write up.. but some of what...

    I didn’t look at the write up.. but some of what you posted is incorrect
  19. Replies
    7
    Views
    290

    Setup stoich as a flex fuel vehicle!!! Stoich is...

    Setup stoich as a flex fuel vehicle!!! Stoich is a multiplier if fuel.. so we don’t want ethanol targeting 14.x stoich ratio
  20. If you open the VT editor and then expand from...

    If you open the VT editor and then expand from 800 to around 1800 (1.8 cylinder load) it becomes apparent the factory VT table is flawed

    This is very important for trans tuning and reported Tq...
  21. Replies
    3
    Views
    145

    Post the tune friend

    Post the tune friend
  22. For what it’s worth.. WOT tuning is probably the...

    For what it’s worth.. WOT tuning is probably the easiest thing to do...
    Takes someone who knows what their doing to control idle speed, off idle, throttle rev and return, light throttle drivability...
  23. Replies
    4
    Views
    180

    Have you done a TB relearn??

    Have you done a TB relearn??
  24. Replies
    4
    Views
    117

    Post tune!!! Either in MAF or SD need to pull...

    Post tune!!! Either in MAF or SD need to pull fuel if rich!
  25. I do a lot of resto mod tuning... post the tune...

    I do a lot of resto mod tuning... post the tune and I’ll take a look
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4