Search:

Type: Posts; User: zshawnz

Search: Search took 0.00 seconds.

  1. I believe the miss is from lean fuel conditions?...

    I believe the miss is from lean fuel conditions? I've got bank1 to read now but it won't read over 5%, which Im assuming is still no good as the other side is over 20%. It stops missing when I remove...
  2. Thanks everyone for all the feedback. I am not...

    Thanks everyone for all the feedback. I am not sure why it wouldn't be registering that data.

    Attached is my "tune" I haven't really done much but increase the idle and eliminate the DOD/AFM...
  3. Tune help 5.3 Cammed, Hollowed out Cats, No Muffler. 228/230, 585"/.585" 112 LSA

    Hello,

    Finally got my truck running! Turns out I needed a new ECM as the injectors were not firing correctly. Attached is my current scan, after removing the DOD and EGR and setting the base idle...
  4. Replies
    6
    Views
    1,072

    @blindsquirrel I apologize for my ignorance. Do...

    @blindsquirrel I apologize for my ignorance. Do you have any suggestions on how to diagnose the problem? Especially considering what you said previously that I'm not getting an RPM signal? I replaced...
  5. Replies
    6
    Views
    1,072

    Ok, unfortunately it looks like the MAP sensor is...

    Ok, unfortunately it looks like the MAP sensor is hooked up properly. I was hoping I was getting that code just because it wasn't starting. Same with RPM. Maybe another victim of the short...

    New...
  6. Replies
    6
    Views
    1,072

    Crank, no start

    Hello,

    First, I swapped a NON DOD 5.3 that had been rebuilt with my blown up 5.3 DOD motor. Both GENIV. I put my intake and injectors on it. After a lot of trial and error I was able to get it...
  7. I do believe the vacuum issue is fixed and I had...

    I do believe the vacuum issue is fixed and I had it running good for a little while. All of a sudden it went it to Limp Mode but ran 1/2 mile until I got home and now it is having trouble starting....
  8. My calibration is stock I believe all I have done...

    My calibration is stock I believe all I have done so far is turn off DoD. What would you need from those calibration details?

    I found a problem on the PCV hose with the connector and after a...
  9. Okay I figured out what was up with the MAF and...

    Okay I figured out what was up with the MAF and got the coolant temp sensor hooked up. Not getting any codes now but still wont run right. Seems like its missing to me, I checked spark and it seems...
  10. My MAF and 02 sensors are connected. I do need to...

    My MAF and 02 sensors are connected. I do need to switch out the coolant temp sensor connector as I broke the last one when removing. I'll look into what's going on with why those are not working and...
  11. No injector data, after rebuild with cam same fuel injectors.

    Hello,
    Recently rebuilt a iron block 5.3 with a cam and replaced with my DOD motor. I have disabled DOD so far in tuning but that is it. I am not getting any injector data. I am getting either...
Results 1 to 11 of 12