Could you be more specific on this? I cannot find any information what this is and how it's done. I am not having any codes, but still I am curious.
Type: Posts; User: sparkybg
Could you be more specific on this? I cannot find any information what this is and how it's done. I am not having any codes, but still I am curious.
No, you don't change anything. Just made a 07 Commander 5.7 NGC4 swap into 06 Commander, previously with NGC3. When the NGC3 PCM warmed up, the engine started to shut down from time to time with...
Anyone?
Does anybody know when "normal" mode is used, and when "alternate" mode is used in TC Apply/Release page?
Also, there is "Partial TCC Apply" thresholds for normal and alternate modes and in the...
One more question about TCC set points - "Unlock to Partial Lock" and "Partial to Full Lock" are obvious - it will switch to the state when the RPM for a given trottle % is above the value of the...
Understood.
And another question - Torque Management can be disabled from "Engine" section, and from "Transmission" section.
If it is disabled in "Engine" section, but not disabled in...
One more question - does anybody know what exactly TCC unlock, unlock to partial, partial to full, full to partial means?
For example if the TCC is in full lock, how "Full to partial" threshold ...
In the VCM Editor, when editing upshift and downshift profiles, both the X coordinate (trottle %) and the Y coordeinates (rpm values themselves) can be edited. I am curious, is changing the X...
I think you should live with it. IMHO, it is a dash issue - your dash does not understand the messages your PCM/TSM puts on the CAN bus.
Would you mind sharing your tune? I am new here, got my...
PM Sent yesterday. Mine is 545RFE on Jeep WK.