Search:

Does anyone know if this is doable?

For sure for the older ones, 07-11, you only need the left front wheel sensor for the speedo. Which is why our 09 jk seems to have no real issues with the abs being off. With this nag1, because there...

thank you

I don't think that is right though. for every 1 rotation of the tire from factory, the pinion would turn 3.73 times and read 52 pulses. with the 5.38s the pinion now turns 5.38 times for 1 rotation...

Sorry for the question if it has already been answered, but I'm wondering, If I've purchased my vcm suite for dodge, can i simply buy credits to tune a chevy or ford etc? Also, will the scanner read...

ok so we got the 0 displacement to work, abs no longer holds the jeep back. Now to figure out the limp mode issue as the jeep still seems to be stuck in 1st or second gear. theoretically it should...

Hey guys,

I've read there is a way to force the nag1 to use only the autostick function. I was wondering how you go about doing that. Is it simply a matter of changing the settings in the Trans...

So even if we disable abs the computer is still going to look at the tone rings?

Right now the rear sensors are tied into the fronts so the tone ring count is the same. But we may have to switch it to the rear.. we've discussed this before.

Actual gear ratio is 5. 38 but we've done the calculations and told the computer that it's 4.66 gears with 37.75inch tires to accommodate the tone ring difference

It's not showing any code through the reader on hp ir through another.. a Chrysler tech told me it's probably storing a code in the tcm but we may not have access to see it.
Basically after we made...

I'm at a loss though.. we changed that and the vehicle still seemed to do the same. Is it still looking for the abs sensors? Or is it possible that because the clockspring is broken the steering...

When you shut off the abs the way 300srt said.. do you also need to go into trans and disable the esp control thru spark fso and tranny?

we tried this tonight, and same issue. the jeep drove down the road, shifted its way up to third then went limp and go stuck there. We brought the jeep back altered the tire size and gear ratio and...

does it make a difference if the abs sensors are there or not? Right now the front 2 are in and the rears are jumped off of the front, just wondering if I shut the system off completely will the...

Thank you, I will try this and see where it gets me. I have made the changes to tire size and gear ratio. it gets tricky with this set up because the tooth count on the front tone rings is 60 rather...

if it's not possible to tune out the abs system, is it possible to tune out the limp mode that is a result of an unplugged or unhappy abs system?

Hey guys,

So I'm trying to shut off the abs system in our 2012 wrangler jk, and I've run into some issues.

A little background on the vehicle.. 2012 jeep wrangler, front dana 60 from a ford one...

Hey guys,

Just got my VCM Suites Standard, Plugged it into one of our jeep wrangler jk's.. this one is a 2009. I was looking under speedometer for the tire size/gear ratio.. But have had no luck....