Thanks for the replies, For fueling now I have the DSX aux kit
Type: Posts; User: d454brisson
Thanks for the replies, For fueling now I have the DSX aux kit
Attached are my logs with id850 meth 50/50 and no meth. Also current read hpt file and one that I tried to prework for 1050x's that I may buy for more head room.
My questions are:
With My...
Just a year of daily testing,, that's a bargain. I am probably holding off a bit on cracking open this one while I continue to watch and learn on the ZL1. This board and CSP have been great so far,...
Thanks definitely will wideband, plus its a Manual 7spd so no trans tuning required
DB
I am doing some searches here but figured I'd post up direct also. Have a 2018 Z06 that I may just change the snout on with a 2.31 pulley. I have hptuners mpvi2 licenses for my 2014 LSA ZL1.
I am...
I ordered a 9.55 lower which should bring boost down a 1.5 and am looking at a larger cam change. Pulled 2 degrees and have no retard now, I will play with timing more in the mid and center of the...
I think i have my pids or channels wrong. It?s retarding but it?s not reading knock counts or knock sensor
I ll double check the data logs and setups
Was working great until this hang up, think I have narrowed it to the device, of course they are closed. what a day
thanks for your help so far
DB
Do you think its software or the device dongle itself, It hung the car during a read. I had to wait and then it worked fine. I moved changed the low octane table and lowered 1-2 counts of timing in...
Was working great then hung up during a read. NOw it will scan for a few minutes and then drops the scan and appears disconnected No interface found error. Verified OBD2 interface good with aeroforce...
Great now my hptuners device is locking up during scanning and loading
Rgr thanks, it typically wont see that level or rpm much but definitely understand your opinion there.
On the other forum I was trying to get a chiller to keep the iats super low and help with the...
Thanks for your response.
I will copy a low octane table from a stock tune, also the Cam is a JRE rough idle but I am not opposed to going bigger in the cam any thoughts there?
Also do you...
I am getting intermittent KR at the top of some 3rd gear test runs
Running 93 with either Torco or Boostane. Hoping its just winter fuel from local area or a bad tank
I Tr6IX in the car now and...
Still learning and searching, I was wondering if there is a preferred Layout file that people have shared for the LSA motor.
I have been adding channels and graphs per the HPtuner youtube channel...