Search:

Type: Posts; User: * _ *

Page 1 of 15 1 2 3 4

Search: Search took 0.00 seconds.

  1. You are sure there are no vacuum leaks? Injector...

    You are sure there are no vacuum leaks? Injector seals good?
  2. Look in the trans section for rpm & gear...

    Look in the trans section for rpm & gear limiters. I think some software development tossed that in the tcm area... might need to add in credits for that too...
  3. Replies
    4
    Views
    403

    It has always been a capability sought after.

    It has always been a capability sought after.
  4. Replies
    3
    Views
    590

    Not sure which fan still. Few trips to the yard...

    Not sure which fan still. Few trips to the yard and all had clutch style
  5. Intake Manifold Runner Control Valve 2.4L Srt4

    Was there ever a successful deletion of the dodge caliber srt4 Intake Manifold Runner Control Valve?
    I do not see where exactly in HPT where it can be addressed.
    Is it possible to tune it out of...
  6. Replies
    3
    Views
    590

    Which trailblazer had the e-fan? I only...

    Which trailblazer had the e-fan? I only recollect those being equipped with clutch style.
    I looked up the vendor's for my application, but they either are no longer supporting the 2008's or they...
  7. Replies
    3
    Views
    590

    2008 2.9 Colorado Fan

    I'm looking at converting from the clutch fan over to electric fan, but I am unsure which selection in the system file selection on which to choose for it to be controlled by the PCM for T-stat & a/c...
  8. Thread: Upgrade Concern

    by * _ *
    Replies
    6
    Views
    345

    This! How can i be reassured that what i can...

    This!

    How can i be reassured that what i can do with the software I'm currently using will not be disabled, hindered, be more cumbersome, and whatever else by a later version software?
  9. Replies
    1
    Views
    170

    atomic calibration?

    will HPT have in the near future a feature built in the software to self-calibrate the pcm? I know it wouldn't be the end all be all tune, but if the engine build does not have a stock file to use,...
  10. Thread: 2006 G35x

    by * _ *
    Replies
    0
    Views
    172

    2006 G35x

    Will HPT scanner be capable in resetting all DTC's regarding a 06 G35x Sedan? A friend is asking for my help to R&R the powertrain, but I am uncertain if the HPT software supports resetting any...
  11. Replies
    3
    Views
    247

    yes

    yes
  12. Any sockets in the ALDL pushed back? Are the HPT...

    Any sockets in the ALDL pushed back? Are the HPT connector pins good?
  13. Thread: 2009 VIPER issue

    by * _ *
    Replies
    6
    Views
    951

    ^ im not 100% sure what your tables are showing...

    ^ im not 100% sure what your tables are showing regarding terminology, but is that similar to setting the max torq - torque limit vs. rpm values all to the highest # to each rpm table listed for that...
  14. Replies
    1
    Views
    437

    The trans being used would be from a 2011...

    The trans being used would be from a 2011 colorado. Not sure if the modules would still be needed going in to the 2008. ??
  15. Thread: Start/Stop

    by * _ *
    Replies
    8
    Views
    570

    OP it should work. No way to reverse the...

    OP it should work.



    No way to reverse the default setting to being always off, toggle to turn on? Relay switching?
  16. Replies
    1
    Views
    437

    08 Colorado Auto to Manual

    Does HPT have the ability to reflash the preexisting modules that are in an automatic truck to support the installation of a manual transmission? Does the IP cluster need to be swapped or BCM need...
  17. Replies
    4
    Views
    366

    the device that contains the software doesn't go...

    the device that contains the software doesn't go online much. Until it drastically impacts my hobbies, I try to leave be what works for the most part & limit the interactivity for resolving any...
  18. Replies
    4
    Views
    366

    Is the 3.0 and 3.0 beta scanning software...

    Is the 3.0 and 3.0 beta scanning software supposed to support that vehicle?
  19. Replies
    4
    Views
    366

    Unable to read DTCs

    Have a check engine light illuminated & when connecting the software to the 2013 Acadia Denali to read what fault is being stored, the Scanner shows no stored DTCs.

    I thought the HPT Scanner has...
  20. Thread: VCM update

    by * _ *
    Replies
    3
    Views
    480

    when you down load the ms frame, did you run the...

    when you down load the ms frame, did you run the file?
  21. Have you tried any other values for change? 68.60?

    Have you tried any other values for change? 68.60?
  22. Thread: EPA is starting.

    by * _ *
    Replies
    24
    Views
    2,533

    x2. Yet the EPA wants all internal combustion...

    x2. Yet the EPA wants all internal combustion engines to be comparable to electric vehicles... When an entity has the ability to influence or direct something they are not 100% knowledgeable in,...
  23. Replies
    3
    Views
    264

    2008 caliber srt, 2008 colorado, 2000 neon r/t. ...

    2008 caliber srt, 2008 colorado, 2000 neon r/t. I know for certain it was not resetting the SRS & radio codes for the three vehicles nor the TPM dtc for the two equipped in order to troubleshoot the...
  24. Replies
    3
    Views
    264

    Scanner resetting other obd2 codes?

    Would like to request the scanner software to be updated to support & execute the process in resetting the other modules that are onboard the domestic vehicles. Such resetting involving ABS, SRS,...
  25. Thread: EPA is starting.

    by * _ *
    Replies
    24
    Views
    2,533

    meanwhile the drug abuse & sexual misconduct...

    meanwhile the drug abuse & sexual misconduct cases are steadily increasing....
Results 1 to 25 of 374
Page 1 of 15 1 2 3 4