Search:

Push

Got a base tune. Can someone possible check if this is ok to start and drive it daily without WOT?
My appointment for the final dyno tune is in 2 weeks.

129624

But the tuner got the only Dyno and Wideband within a two hour drive...

I thought about that, too Greg.
I wasn’t sure about driving the car after these mods to him or even start the car. Therefore I asked here.
Because it’s a reputable tuner (for Dodge) and actually...

Push

Hi guys,
I'm doing a Lt4 conversion on my Lt1 and also a cam swap.
My tuner said it?s not needed. I should be able to start the car and drive it to his dyno (around 80-100miles)
Do you know if...

Push

Thank you. Hptuners told me that it is possible to do it „by click“, because they added these definitions already.
But they could not tell me where they are and I also couldn’t find them.

Do you...

Nobody?

Hi guys,

I talked to the HPTuner staff and they told me there is a function in VCM Editor which sustains the last used mode over ignition cycle. No matter in which mode you were before.
With...

Nobody?

He has to take his car into neutral on red traffic lights, otherwise the engine stops running sometimes.
Because we never saw or driven a cammed car here in Germany, we don’t know if this...

Hi,

a friend of me own a 2017 Camaro 2SS automatic with LT1 and got it cammed, DOD delete, CAI and a cat-back exhaust.

Because we know, that some tuning shops in Germany sometimes throw bad...

I'm hoping HPtuners will give us access to these paramters in near future. This problem sucks and I wan't to get rid of it. And unfortunately no one here will post the solution...

worked. thanks

On my own car (EU Camaro 2018 automatic transmission) I did only a system swap to get rid of the 3rd gear problem.

...

Thank you. Is this a manual? I ask because the car doesn’t start. It’s like it doesn’t recognize the clutch.

Didn't helped. It has OS 12678648 instead of 12688025. Thanks anyway

Hi all,

do somebody have a US stock file from a 2018 Camaro 2SS with manual transmission and could probably post it here?

I need to do a swap but thats not possible with the file from...

Any updates on this? Will it be included in upcoming vcm editor versions? Thank you