I did, I basically just stopped smoothing the data and the let the math work. She's runs like a champ on SD only, but I do run blended
Type: Posts; User: pbarton2120
I did, I basically just stopped smoothing the data and the let the math work. She's runs like a champ on SD only, but I do run blended
105565105566
sorry for the long delay
On my 2017 ATS, I've done the same thing and had to turn off close loop in the special functions tab under fuel. Afterwards I restart the log to get true open loop data.
you can, but depending on your fuel requirements you may be able to adjust the FCM. I did mine and now my requested PSI is more in line with requested.
its in the beta 4.7 version, just checked
i did notice the sensor enable on parameter 20220 is gone in the new version 4.6, It was in the 4.5 beta because thats how i enabled it
Im using the ZZP Sensor. pinned to the #70 on x3
My '17 works no issues, currently running flex at E40
Code has been broken on the '17's I am currently running e85 on my LTG with the e80a ECM. Latest version on HP supports it now.
Latest beta update works, confirmed it last night
I have a '17 ATS LTG w/E80A ECM and was told the code had been cracked for Flex Fuel. Sensor has since been installed, but the sensor is not working currently. Working on figuring this out as I...
I cant see your calibration file, can you reattach it?
Thanks
On your e80a ECM, does it have flex fuel sensor drop down under "Engine/Fuel/Flex Fuel"?
Question for the group and HPTuners:
I was told that the code had been cracked on the 2017 Cadillac ATS for enabling Flex Fuel, so I purchased the sensor and installed it. Went into HPT (w/latest...
Trudat! My bad in not describing my intentions, I was in a bit of a rush last night. Thanks, next time I'll be more specific.
-P
looking for a set of PIDs to start pulling logs on a manual LS3 G8, can anybody assist?
Yeah but soon as I start adjusting and getting some fidelity on the VVE table, the predicted torque numbers go wacky and start closing the throttle body. I can?t figure out how to get that straight
I went back to the zones under engine-airflow-dynamic, and adjusted the zones a bit and equaled out the pressure ratio boundary?s. I?m gonna start logging this weekend and see how I fair out. ...
I have been working with Kyle to try and figure this out off and on, probably just need to do a one on one with him and see if we can crack this nut.
Attached is a screen shot of the VVE Zones and...
94157 94158
See the VVE table attached
I also added the factory 3D Graph, its a mess from the factory
No your spot on! I have interpolated the sections of data collected and multiplied by half percentages surrounding the data to smooth out transitions. However, with all the CAM angles, there are...
So for a while now, I have been trying to optimize my VVE tables on my 2.0T LTG with E80A ECM in a '17 ATS.
I am running into a wall when modifying my VVE table. There are so many variations of...
lt1z350, do you have any info on the '17 ATS 2.0T E80A as far as tuning goes? I am having issues tuning SD in the VVE table. I'd also like to know anything you have on flex fuel for the '17s.
...
were there any modifications done to the VVE or MAF tables in the tune? I apologize i cant look at the tune right now, I am on a work computer.
you should just need to put a "-" negative sign in from of the o2 voltage, that should keep it in OL