Search:

Hey Mark Bite the bullet pay the money and get https://thetuningschool.com course
on the ecoboost. If you just adjust the parts that make the throttle open your computer
is going to fight you and...

I changed mine quite a bit. I was getting boost and lean a/f ratios. Now a/f ratios come down a lot
quicker and I get much smoother response rolling into the throttle.

Here's how I have mine...

I'm having some issues adjusting my speedometer. I've adjusted my N/V Base and Tire size, but I see no change on my speedometer read out vs GPS speed.

Its still off a solid 5%. Maybe I'm missing...

Haven't posted on this in awhile. Fixed my problem by adding an external wastegate. The internal one could not keep up for some reason. With the external on there is no boost surge it comes up and...

OK I've got the waste gate stuff figured out..

I'm still running into my Predicted TIP being much lower than actual. Need to get my Desired TIP much Higher.... Any Ideas?

I see, I'm thinking I should just go get an aftermarket waste gate controller.

Next thing is how do I get the Predicted TIP higher?
Has any one modified the pressure/volt of the TIP sensor to...

3rd gear its very cold here clean roads but i have snow tires on the car so I'm sure it's spinning a little...

I'm confused with the blow through logic when I turn it off my waste gate duty just...

Ok so I fixed all that now it doesn't say there's anything limiting air flow but it's still being limited. I think i'm beginning to understand this i'm hitting a lot of boost and my waste gate duty...

Awesome, yeah I'm really excited to learn this stuff. I actually work at a Chevy/Buick/GMC/Ford/Lincoln dealership as a salesmen. From what I can see, even though this stuff is very complicated, this...

I will log that tonight and post it here I wasn't logging the WG duty cycle
but I will add it. Can you see anything else i should be logging that I should add?

I ended up buying a 13 Focus ST with tons of upgrades but the prior owner kept his Tuner and took the tune out of the car. I have done a lot of stuff on my SRT8 Magnum, but now I'm stuck on this one....

What Ended up being your fix?

following

A tiny shot is all I'm going for, if I can get 35 to 50 to run safely I'd be pickled tink.

I just want a little more run down at the end of the strip.

That's Genius.... Wish I would have known that idea back when I was spraying N2O on the IAT sensors on bikes.
Never had a problem but could have made the results more tune-able. Resister output in...

I don't know if anyone has tried it, but I'm looking at installing a 35 to 50 hp small shot of dry nitrous.

I'm thinking about putting the nozzle by my IAT sensor. I'm looking at what adjustments...

Right on, I've learned a lot in this on transmission set up.

So me being at best right around 400 pounds will be good.

To set torque lock up that's just setting output shaft speed vs throttle vs rpm in the normal lockup section?

For example my 1-2 WOT...

Fixed it in the Torque Management. I raised the torque limit in first gear. After logging like 06300CSRT8 suggested it showed I was momentarily going well over the peak when launching.

I also...

What would cause the transmission to think it was in neutral even though its in first until I hit almost 20 mph?

I've done some minimal adjustments to torque management for the most part copying...

There's a throttle lift for knock? At .6 of a volt? how do I turn that off.....

No parts banging I was worried about a ticking noise last week, turned out to be an exhaust leak but I just checked...

I'm getting throttle dip at full throttle!! Traction control is turned off too.

Not sure what I need to adjust, but I have the throttle completely against the floor the entire time.

Here are...

Ok that makes sense

06300CSRT8 you rock dude lights just flipped in my mind I think im starting to understand whats going on then.

So is the Vehicle essentially in speed density mode already? What is determining the short term fuel trims?

My end goal is to supercharge my car but initially here I'm getting a baseline for new...