Great video!
And I would heed the warning from Ruthless too. Keep an eye on AFRs, and at the very least change the stock desired fueling to something safer in the Fuel > Power Enrichment tables....
Type: Posts; User: ninjawarrior821
Great video!
And I would heed the warning from Ruthless too. Keep an eye on AFRs, and at the very least change the stock desired fueling to something safer in the Fuel > Power Enrichment tables....
No idea, but I think it's effecting me to at sea level.
Yes, it does.
But you want to replace the Default Channels file with the desired channels first, then write the channels to the unit.
136176
The data in the background was taken from an MPVI3...
I got the standalone to log more channels!!!
Not exactly sure how, but here is what I did.
1) Non-Beta VCM Scanner (Needed for Bluetooth, but not used here)
2) Replaced the "Default.Channels.xml"...
Getting just over 13 psi at 8100 rpm here. Stock charger.
I wouldn't want my motor doing 70 at 8 grand if there was a fault in the engine. It seems like it could be a limited based on speed to avoid cavitation maybe? Still haven't taken the ski out yet.
I may have found another limiter in the Fuel:Cutoff, DFCO section. It's the VSS Fault table which mysteriously ends at 70 mph and 8000 rpm. I'll make some changes and keep y'all updated.
Went from 70ish to 73ish, still needs some fuel changes. But still stuck around 8100, maybe it needs timing as mentioned by Yann45, currently running ~31 deg.
There's a setting in the Torque Management tab of the tune where you can disable the break in mode. Sorry, for the slow response, hope the race went well.
134939
Yeah, I've been limited to the same channels in stand alone mode, kinda a bummer.
Took the ski out on the high sea with a laptop hooked up in the frunk, managed to shatter the usb cable when I hit...
I found a torque limiter recently. It was based on battery voltage. I think it is intended to cut power if there are major electrical issues, but it also had a mild cut above 8000 rpm. I haven't gone...
Oh, my b my b.
That would be nice to know, to see if limiters are active or whatnot.
Yeah, this place is not too lively. I've been logging Accelerator Position just fine without a laptop hooked up. I'm running the beta VCM softwares, maybe update the firmware on the MPVI3 (if that's...
I found that the Beta version of VCM Editor has the GPS Adder setting. Even with that maxed, I'm still not surpassing 71ish too.