Looking at newegg I found this, looks promising. IOGEAR GUCE51 USB Ethernet Extender
Type: Posts; User: MattB
Looking at newegg I found this, looks promising. IOGEAR GUCE51 USB Ethernet Extender
I've been meaning to get back to this thread and say thanks to Mowton for stepping up to the plate. However, does the config have some custom pids or something? Maybe I'm just not using it right LOL...
Thanks man, that is at least something to look into.
I hope to get back to the 'tuner' and use his wideband and dyno again, but I plan on running the controls this time. I know the fuel burns...
Ed,
I agree, I was quite disappointed with the 'tuners' work. And, this is not the first 'tuner' I've tried, can't seem to find a tuner in CO. I should do a scan with out PE and see if that...
Hey, no problem. But first, the smoothing did nothing for the retard, still go the same amount.
Yes, I need to get back to a dyno with a wide band to re-do the PE. The 'tuner' I went to at the...
Thanks, I'll give that a try. I had logged spark smoothing before and had not seen anything for it, so thought it was not doing any smoothing.
What does the smoothing do?
Hey,
I have an issue with Torque management and/or Traction control. I have tried to disable Torque Management, and tried to lessen the spark changes associated with Traction control. However,...
Hey, you need to log several of the advance and retard pids to get the answer. Its not as hard as it sounds. Just take the default config file and add in the pids, right click on an empy cell in...
Thanks for the reply, but ya, not burst knock. Logged it, zero. Was hoping someone had a config setup to monitor almost if not all aspects of advance and retard, mostly for future logging. You...
Beuller? Beuller? Beuller?
Looked in the repository and searched some, did not find any configs that logged a whole lot of spark data.
If anyone has a good cfg and some histograms that would be great. I have not learned...
I think I'm getting the VE table dialed in, still get some wide variations from log to log. I think some of that is the weather, we get some wide temp swings here in CO. I did have all the same...
Well, it looks like my VE table is a little different, but not a whole lot. The high octane table and the Idle Spark Advance In Drive table are different. Between dialing in the VE table and the...
I have that cam, and I was really surprised with the changes in idle when I set the timing advance a lot higher than I had it at. My latest scan shows I'm running about 28 deg at idle, and it jumps...
Updated my sig :)
I also forgot to mention that this car was originally a auto trans and I converted to manual. I'm near 90% confidant that I updated the tune correctly to reflect that its a...
Well, first my car: 00 Vette, LGs G5X1 cam (228 232 .588 .574, lsa114), LG LT headers (street), PRC ported 243 heads. ls6 intake, 5 pin MAF, PRC dual springs, LS7 lifters, hardened push rods, stock...
I had actually done that with more than one tune as suggested on this forum. However I'm surprised by how much 'stock' tunes differ. Was looking to see if I had any obvious mistakes, or over...
Hey,
I did a conversion to a mn6 trans on my 2000 C5 Vette. Things are going pretty well, but not perfect. I was trying to alter my tune rather than upload a different one that was originally a...
Running vista. I installed the USB drivers mentioned above, it only installed channel B. Went into the device manager and did a update device driver and it installed channel A. I can bring up VCM...