I had two base GTO files but neither matched what you posted ... I will try and use what you listed.. So at 196 degrees put 50 that turns on number 1 Fan when i put 98 in 200 degrees it will have...
Type: Posts; User: Casey23
I had two base GTO files but neither matched what you posted ... I will try and use what you listed.. So at 196 degrees put 50 that turns on number 1 Fan when i put 98 in 200 degrees it will have...
Thanks for the reply.. The State vs Desired % is stoc I didnt change it..and looked at 2-3 others and its the exact same ... I didnt change that one only the Fan desired but nothing changed.. I...
Fans come on as soon as the key is on .. I have Turned the codes off for the AC compressor . I have changed all values in the Output state vs Fan controls I thought these were PWM fans but the...
I reflashed my truck after doing a major fuel system swap and it will hardly run !.. test fuel pressure,change plugs,compression.no codes when i start it and let it idle its not many any heat in the...
I am wanting to go from my moton 60lb injectors to the RC72s... I run a 1:1 Boost Refrance reg so i understand my IFR should match all the way across the board... but my tuner set my IFR bs KPA...
I am calling in the morning for all of that Rus.. Thanks for the response... I was wanting to be productive... My HPtuners computer shows about 10 degrees more then the Cluster... think I have...
I can do it... but it will cost 2 credits and a 44oz DP... but I am 10miles from him...
I took a log file today doing a few scans and my truck is getting some crazy KR.. @ 4000 rpm range... out of the blue.... I am scared and would for experts to look at this and advise... :confused:
Not enough info? baseline hand held download?? :confused:
The truck runs decent.. but i see alot of KR under light throttle... I was looking at some trans values tonight and made a few changes.. then took it around the block with the Scanner on....
I was wanting to load my first tune/scan since i went 1bar... I am sending my first tune/scan I made a total of 7 scans today ... also posting my last tune/scan
:banghead: I am having major problems with my config files that were posted under the sticky... Only half of them work... I cannot get a consistant STFT error table so i can make ajustments... I...
:doh: The problem isnt with the tune,or electrical.. problem seems to be mechanical...:rolleyes:
the truck had a new sensor installed and the known working used unit and bolth with the same troubles... Trans is Rebuilt/Truck had a new/different non proven PCM installed, speartech 80E harness...
I just put a 410/4l80 in my chevy 1500 with new GM speed sensors.. I used the speartech harness ... truck was apart for 3 months and now my speedo is off like crazy I installed new output speed...
How about rockerarms... Valve train.. Any brackets on the engine lose?... Alot of built motors are pretty loud with Roller rockers...