I almost wept for joy when I read this.
Thankyou Eric, for actually fixing stuff.
Anyone - How do I get the latest beta?
Cheers,
Chris.
Type: Posts; User: Bad Apples
I almost wept for joy when I read this.
Thankyou Eric, for actually fixing stuff.
Anyone - How do I get the latest beta?
Cheers,
Chris.
That would be truely beautiful if you could reveal it. Please have a look at BA F6 ute strategy HAAT3VC.
Also, if possible please have a look at where the "MAP per Airmass" writes to. It doesn't...
Sure, but if you don't support them, no one will come.
Hi All,
My load values are lower than the calculated LOAD, which I thought should mean the ECU would have to pull fuel.
It isn't.
I have a wideband installed and it always go lean, when i...
Hi All,
My heavily modified BA Haat3 appears to be intermittently referencing the decel spark map when cruising at ~1500 rpm.
Can someone tell me what the rules are for deceleration spark to be...
For may BA, I actually think the data connectivity is better than the obvious competition.
The datalogging on HPT works every time, where on the competition it often requires revs to stat...
Hi All,
I recently wanted to run some tests on the vct, so I set the VCT for rpm vs load to a flat 20.
It did not seem to do much.
I have included the log and cfg here for the scanner, the...
The idle is very good, but after sitting at the lights for a while, sometimes it chucks a limp mode. I haven't got it to do this while logging but i'm pretty sure it is getting the fuel trims off to...
HI All,
I have installed bigger cams in a ford turbo BA F6, and I think I'm suffering a bit from increased overlap, without a free flowing exhaust manifold.
My question is how do I keep the...
When I try to open the demo editor I get this:
"The application failed to initialize properly (0xc000013). Click on OK to terminate the application."
fresh XP install, minimal other software.
...