Search:

Type: Posts; User: SultanHassanMasTuning

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    100

    you will need to get it done right to drive right

    you will need to get it done right to drive right
  2. which vehicle

    which vehicle
  3. i have seen this happen when you activate the rev...

    i have seen this happen when you activate the rev match feature
  4. Go Advance

    Go Advance
  5. yes your torque tables would be far off which...

    yes your torque tables would be far off which will not have you get into PE
  6. attach your current tune with datalog with...

    attach your current tune with datalog with correct PIDs selected so we can see and point you in the right direction
  7. throw them in the trash, i have on mutiple...

    throw them in the trash, i have on mutiple occasions tried with different sizes and injector data supplied from SEP

    its not consistent at all

    want to save, go for FIC at least
  8. 104950 if the car only has LT headers i...

    104950

    if the car only has LT headers

    i would install a wideband
  9. i doubt you will find such a file

    i doubt you will find such a file
  10. post your tune and data log if you need any...

    post your tune and data log if you need any support
  11. did you do a crank relearn? after the clutch

    did you do a crank relearn? after the clutch
  12. Replies
    6
    Views
    297

    if you still have ethanol in your tank it will go...

    if you still have ethanol in your tank it will go lean of course
  13. never trust extensions your issue is wiring...

    never trust extensions

    your issue is wiring for sure

    adding headers in most cases you will need to pull some fuel at low engine loads
  14. could be something wrong with o2 sensors

    could be something wrong with o2 sensors
  15. post your file and log

    post your file and log
  16. post your tune

    post your tune
  17. i would raise some of those limiters under torque...

    i would raise some of those limiters under torque management maximum torque
  18. post your file and log of current issue, i am...

    post your file and log of current issue, i am sure many of us can help
  19. there is a lot of missing parameters in your...

    there is a lot of missing parameters in your datalog,

    cyl airmass
    MAT
    inj PW 1 and 2


    major issue your having is a drop in fuel pressure with does not help with atomization

    looking at...
  20. smaller superchargers are more efficient in low...

    smaller superchargers are more efficient in low end torque and hp, same idea with camshaft bigger you move the power band higher...


    a log would help
  21. Replies
    7
    Views
    643

    ^check PM

    ^check PM
  22. raise your idle speed for sure factory 625 not...

    raise your idle speed for sure factory 625 not good

    you need to know the injectors installed as well
  23. its just not possible, you will need to build a...

    its just not possible, you will need to build a new tune with HPT file
  24. contact support, issue with definitions. also...

    contact support, issue with definitions. also could be that its not a stock strategy
  25. Replies
    7
    Views
    643

    ^ you need to post your tune for any help

    ^ you need to post your tune for any help
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4