It's a very low mileage (6miles) engine from a damaged in transit car that had to be scrapped. I don't think the wheel is a problem but I guess the only way to make sure is to drop the pan and have...
Type: Posts; User: HFV6MGB
It's a very low mileage (6miles) engine from a damaged in transit car that had to be scrapped. I don't think the wheel is a problem but I guess the only way to make sure is to drop the pan and have...
Thanks for the tip. Even though those Crank Sensor codes aren't set, I already suspected a crank sensor issue that's why in my previous post I mentionned that I changed the sensor and checked the...
Still no luck. The engine won?t fire.
I?ve checked the wiring for most critical systems (crank sensor, cam sensors, injectors, ignition coils) from connectors to the ECM pin per the attached 2007...
Hi Bill,
Given that it does fire when I use ether. It seems that all the other systems seem to be OK except the fueling and I don't have any codes set.
I have not provide any inputs for,...
OK Thanks. I'll check.
I've already tried an entire write, not just cal. with no affect. It fires briefly when I use quick start (ether) but then dies, confirming that it is a fuel only issue.
I'm getting frustrated. ...
The starter diag is already disabled. Its ECM 730 if you want to look at it.
I wrote this already but you have to do a write entire to disable vats.
Hi Alvin, Here's the file
Hi Alvin, thanks for the reply. Yes I did an entire write. What starter checks are you referring to? I am running the starter manually. There is no start circuit to the ECM. I assume that in the...
Hi All,
I need some help.
I have a 3.6 HFV6 enigne from a Pontiac G6 in an MGB using an E67 controller configured as a Pontiac G6.
I can't get it to start. I believe it's a VATS issue as I do not...
HI, No have not yet solved the problem but I don't think it's battery related. I am running two batteries, one just for the starter and another for the ECM to ensure adequate voltage while cranking.
Hi All, I need help !!
I have an 07 Pontiac G6 3.6L V6 with an E67 ECM installed in an MGB with a Manual transmission (but have a TCM in the CAN circuit to avoid any possible problems since the...