Search:

Once enabled by the ecu, they never shut off till we shut the car off via ignition switch. Scanner allows us to enable and shit off fans while car is running. Ignore the goofy file names as I used...

The large aluminum tank behind the seats contains a large air filter. It's foolish not to run a filter. The maf is still physically in the system because we are using the integrated inlet air temp...

Yes and i have also set it to values of 20-50. Same results. No fan shut off after cooling.

Fixed issue by replacing MAP with a 2006 cobalt instead of 08 cobalt that was in the engine.

Engine is in a sand rail with a single relay not PWM. Fan turns on at 201 like it should at my setting. Once the engine cools down well below what I thing is cool, (175) the fans never shut off. ...

I accidentally posted in the V6 section so I created a new post over here where it's supposed to be.

Ecotech Sand Rail starts and runs fine except idle surges after idling for about 30 seconds and...

Dang fat fingers. I will try to move or create an new post over there.

Ecotech Sand Rail starts and runs fine except idle surges after idling for about 30 seconds. WOT is great. eee datalog is a wide open throttle acceleration run. Fuel system is all new with 58psi...

Measure heater voltage at O2 sensor connectors.

I have tried on several v6 PCM to do a write entire and load a 02 Camaro OS. Most of the time it results in weird errors or no starts. I use tunercat and do a write entire with a Camaro file and it...

M6 does not have the in gear idle tables populated so just start it and let it idle for 5 to 10 minutes and again with the Ac on. The pcm needs to correlate the throttle body and commanded idle...

Do this idle relearn.

http://www.silveradoss.com/forums/topic/34367-idle-relearn-procedure/

So I figured it out after the car finished the car show tour.

I was running a automatic calibration and shutting off all the trans codes because the 4L80e was controlled by an aftermarket...

Ok, car is at the street rod nationals in Louisville, KY this week. Once it gets back I will be able to do more testing.

Anyone ?

6.2L, twin 80mm garrett turbos,96lb injectors. The car starts and runs great, idle is good. I set P0068 code tests to 8000 rpm, no SES and no error reported. It goes into reduced power mode the first...

http://www.ls1gto.com/forums/showthread.php?t=250178&highlight=lean+cruise

Normal imo.

Pcm's are not crappy and pull timing unless told to do so by the engine sensors or too much timing. Typically the older injectors are gummed up with gas varnish, have a weak fuel pump, noisy valve...

Anyone?

Engine swap. '04 LQ9 4L80E 373 gears, manual cruise in a '68 Chevy truck. Starts, idles, accels, shifts and cruises perfectly. Only thing is I can't get the cruise to function. It's wired up using...

Select ac recirc under fan setting type to enable second fan.

See post number 19 here:

http://www.hptuners.com/forum/showthread.php?t=33814

These have small truck injector connectors not square flex fuel connectors. There is no reason they cannot be set upto function. Dimensionally they are different than LS1 style injectors.

Anyone have injector data for these? i have a set on a turbo 5.3L truck and am wanting to use the correct data in my hPT file.
...

Nevermind, after transposing the output fuel gage level table and all is good.