Search:

Type: Posts; User: Admir101

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,783

    What did you use to load the original PBD tune?...

    What did you use to load the original PBD tune? Is it an sct device or similar?
  2. Replies
    9
    Views
    1,751

    Thanks for the info, I will definitely give it a...

    Thanks for the info, I will definitely give it a shot and try tuning this table then.
  3. Replies
    29
    Views
    39,437

    I was wondering the same thing, it's just a link...

    I was wondering the same thing, it's just a link to another forum now...would be a good read if it was still available.
  4. Replies
    9
    Views
    1,751

    Yeah I'll play around with the transient time...

    Yeah I'll play around with the transient time constant and report back. I will say that turning tip in management and the oscillation off did wonders for the pedal feel. Not sure why ford had this on...
  5. Replies
    9
    Views
    1,751

    Ok thanks I'll look for that, also tip out spark...

    Ok thanks I'll look for that, also tip out spark is maxed out from the factory at 60 degrees. I'm assuming this would be advanced correct? Im not sure if it even uses this with torque based decel.
  6. Replies
    9
    Views
    1,751

    Thanks I saw those, even at 100 which is the max...

    Thanks I saw those, even at 100 which is the max value there is some time before it enters. I think this is maybe how aggressive it enters dfco?
  7. Replies
    9
    Views
    1,751

    2014 Mustang time to get into DFCO

    Hello, im trying to work on my throttle reponse/drivers feel. Throttle on is pretty dialed in but I cant seem to tune out the lag when throttle is off before it goes into Decel fuel cut off. It does...
  8. Replies
    5
    Views
    1,350

    Check out my thread called "Cold start Cat warm...

    Check out my thread called "Cold start Cat warm up timing table". On my 2014 I was able to adjust this and make the car start normally. Although some in the thread said it did not work for their 18....
  9. Replies
    20
    Views
    4,763

    So I can confirm on my 2014 gen 1 it did the...

    So I can confirm on my 2014 gen 1 it did the trick. The Adder, Base neutral and base drive tables under the emission reduction section I made all the values 55 on all 3 tables and the car starts and...
  10. Replies
    20
    Views
    4,763

    I see thanks for the reply. I'll check mine when...

    I see thanks for the reply. I'll check mine when I get my device but there must be a way to adjust this.
  11. Replies
    20
    Views
    4,763

    Did it reduce the startup noise? its just so...

    Did it reduce the startup noise? its just so obnoxious without Cats when it does it for the first 15 seconds.
  12. Replies
    20
    Views
    4,763

    Awesome there they are Thanks. I didn't expect...

    Awesome there they are Thanks. I didn't expect them to be under the Adder. Still getting used to all the terminology. Yeah im gonna play around with the timing and see what gives me the best cold...
  13. Replies
    20
    Views
    4,763

    Cold start Cat warm up timing table

    Hello, I'm new to tuning and mainly got HP tuners to try and tune out the cold start Cat warm up mode in my 2014 Mustang. I want to learn more about all the other parameters and this website has been...
Results 1 to 13 of 14