Search:

Is the 2015 Equinox 3.6L supported? Having trouble pulling the stock file.

I know this is an old thread, but I?m having the same issue and can?t figure out what is causing it. I have new sensors installed. They seem to be getting power. No codes. Won?t go into closed loop.

Tried contacting tech support, but it says access denied, even though I was logged in. Is there someone from tech support that can look into this please?

All of a sudden, I'm getting messages that I don't have an interface license. It worked once more then back to the same. Now won't connect at all. Anyone have this issue?

Swapped with a fresh build Low boost LT4. installed a 3 BAR map, but the scanner is not logging MAF or MAP. Possible culprit/ solutions?

Also, I have the rear 02 codes off, but I am still getting...

Anyone have a baseline tune for the 6.2L they could share? I have an SLP 1900.

Here is my tune file. I don't have a log yet. I'm a newbie and still learning.

I have a 2010 Silverado 6.2L... 3.73 gears and stock size tire. I have a Circle D triple disk at 2600 stall. I had my truck tuned on a dyno in HP tuners format. Seemed to run fine out to about 4-6...