we've added support for these in the newest Alpha firmware, if you would like to be added to the Alpha firmware list for this application please contact support directly with the Subject Jtec Alpha firmware Assign to Bill@hptuners and in the body of your message add your MPVI3 serial number and we'll get it added to your account.
Alternately you can wait until its out of Alpha firmware testing which might be a few weeks.
Last edited by Bill@HPTuners; 10-26-2022 at 11:54 AM.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
I sent the message to support as requested, and received a reply (Ticket #70255) with instructions to update the firmware via the Beta version of VCM Suite. After following the procedure, no firmware update was pushed to my MPVI3 and I replied to the support email with that information as well as debug and interface information files.
I emailed support and was told that jtec+ isnt currently supported by mpvi3 but will be available in the future.
I'm sorry for the few that fell through the cracks, I'm working on adding several now and hope to have them updated shortly. I apologize for the delay. I've also revamped the instructions so that all of these tickets go to me in the future so there is no confusion.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Bill, understood on the scramble to get things moving. No worries, appreciate the extra effort to get things fixed. I'll try to resync again later and see if the firmware pushes by thenOriginally Posted by Bill@HPTuners
everyone that has requested the Alpha access has been updated as of today. Again thank you all for your patience.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Has anyone with a no-start vehicle been able to get this to work? Mine gives a baud rate timeout and after communication with support was told to have the PCM reprogrammed elsewhere and then try HPT again.
Getting the exact same error message. Does this mean it has to go to a dealership or can a snapon scanner do it also?
No clue, but if the solution is paying someone else to fix the issue that HPT created, you can bet I won't be using or recommending HPT for anything but GM.
Any solution to this cluster f&$@k yet?
Hello Bill@HP Tuners, if I order a MPVI3 now, will it support JTEC when I receive it? (2001 Dodge Dakota). Thanks
Highly unlikely.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Not as of yet, still a work in progress.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Thank you for the information Bill.
I take it there is still no resolution. I should have bought the V2 a while back....
Still working on the resolution.
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
Thank you for the update Bill.
New member here, just wanted to post in this thread so I can keep up to date on the progress. I've got 3 jeeps running JTEC pcms, and I'm itching to buy an MPVI3 as soon as they are supported. It's exciting to see you guys are working on it (even if it's not quite there yet)!
Can I deduce from the responses here that you are not currently sending the alpha test update to any more people until the next round of revisions?
Thanks
any update about the Jtec pcms
The MPVI2 will continue to work correct? There's no plans of dropping support for JTEC vehicles in the future?
