Sensor Calibration settings E78 ecm NA-MAP-TIAP

[ryandass15]

I've added a turbo to my engine and am having trouble with the throttle not going past 50%. I changed my sensor config from NA-MAP-TIAP to NA-MAP. it sets baro DTC high voltage and defaults baro to 14.4. My pred. torque is higher than calculated torque. But the throttle wont open past 50%. Ill attach a log, the best example of this can be seen at timestamp 4:17:29. Accel pedal is at 99% but TPS wont open past 50%. Is this supposed to be like this? I think something is limiting cyl. airmass but not sure what. Appreciate any help fellas

[blindsquirrel]

Tune Details
E39A, ECM, GM SIDI
VIN: 2G1FA1E39F9193336
2015 Chevrolet Camaro LS, 3.6L, 6 Cyl

[tunerpro]

Depending on how the original calibration is set up, it may not allow the manifold pressure to exceed what the BARO sensor is reading, because, why would it? It's a naturally aspirated engine.

[ryandass15]

Depending on how the original calibration is set up, it may not allow the manifold pressure to exceed what the BARO sensor is reading, because, why would it? It's a naturally aspirated engine.