Hey guys, im having issues with a 14' silverado with the L83 engine. The truck had a On3 turbo kit installed along with a LT4 fuel system and DW400 low side fuel pump. Ran great for a few months then broke a ring land. Rebuilt the engine with a forged rotating assembly and a stage 2 low lift GPI cam kit. The turbo and fuel system stayed the same aside from installing a new set of LT4 injectors just incase one was damaged when the engine blew up. Now after the rebuild the engine is very doggy and not making power above 3000 rpm. The tuner we took it to could not figure it out so i am looking for some help from all of you guys to see if you could help point us in the right direction. I have attached a data log file for you all to look at. Some issues i see on it is that the fuel rail pressure is only building 1500 psi, from what i'm finding these should be upwards of 2900 psi. I also see that the Bank 2 short and long term fuel trims are stuck at -100%, not sure if this is used for tuning or if this is an issue. I will list the stats of the truck below. Thank you all for any and all help!
- Deatschwerks DW400 in tank low side pump ( https://deatschwerks.com/collections...cts/9-401-7014)
- LT4 injectors and LT4 HPFP
- Stock L83 high pressure fuel lines and rails
- GPI stage 2 low lift cam and the lash cap that was supplied with the kit
- Upgraded valve springs and rocker trunions
- GPI forged drop in pistons and rods
- On3 Single turbo kit
- NGK 6510 plugs gapped to .025 i believe
- Stock converter
- Aftermarket dual exhaust
- 91 octane fuel