13 Escalade, In weather above 40 deg it remote starts great. When its colder like this morning at 28 when I use remote start it starts and runs for about 5 to 10 seconds then just dies. It will not let me remote start it the second time, so I have to go out and use the key. It will start with the key and idle just fine.
that sux..
Typically that means there is a code stored in the vehicle. Try scanning it for codes.
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
If there were a fault code, it would throw a CEL, and the remote start wouldn't work at all, until the CEL was cleared. Not sure if he was asking a question or just making a statement about his vehicle. He really didn't ask anything.
Yes sorry for not making it clear. No CEL on , No codes.. Wandering if anyone has had this and any ideas on what to change to get it to stop..
Recently did DOD delete with stage 2 comp cams with VVT, new springs. The tune I have is not bad, this is my only issue.
I wouldn't assume it doesn't have CEL. I'd scan it.Originally Posted by danmw2003
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
No CEL but did have stored codes..
P219A
P219B
P0011
Permanent or pending? Permanent codes won't disable remote start if they are set to NER. I would just set those to NER.
The P219A and B are pending, The P0011 is Permanent
That is your problem.
Tuner at PCMofnc.com
Email tuning!!!, Mail order, Dyno tuning, Performance Parts, Electric Fan Kits, 4l80e swap harnesses, 6l80 -> 4l80e conversion harnesses, Installs
So how do I get that fixed? What do i need to adjust to cure that
is this just a stock vehicle?
Recently did DOD delete with stage 2 comp cams with VVT, new springs. The tune I have is not bad, this is my only issue.
Last tune I put in800 idle 021423.hpt
You've already been told.
You have to permanently disable those two DTC's. Do you know how to do that?
Not really.
In the Engine Diagnostics Under DTC's I have those 2 codes unchecked..
Ok after some googleing I found out how to edit the DTC by clicking on How it reports and set to No report.... 2xls1 I did not see where you said to set it to NER... Thank you ...And for the others that chimed in thank you as well. I am an old school rodder and this computer stuff has me at a loss...If this wasn't my own truck, I would say take it somewhere else... But I can't let other people work on my rides, just not in me.
That's why you weren't getting a SES light with set codes.
Reply With Quote