I have done a Jeep speed shop swap on my wrangler and am looking to verify its at least running correctly before I even start to think
about learning to tune for performance.
I believe Im running a 2009 ish grand Cherokee 5.7 ecu with a challenger tune/flash. Im not sure this is correct as Its tough to get answers sometimes with details.
I have credits and installed an AEM wideband gauge 18 inches or so from the stock manifold in the down pipe. Seems to bounce a lot between 14.6 and 15.2 when at idle.
Is there anyone here that could take a look a log file for me and see if the basics are correct? I did a log running down the street with a little WOT and normal driving. Not even sure if I logged what I need or am setup correctly to log.
Thanks in advance for any help. I can paypay small fee if needed for the help uf needed.
TC.