AEM Can Pass-Through Disappears When Scanning Starts

[Binshou]

I have my AEM connected through the OBDII pass through (MPVI3) and the correct PID selected in the channels list. I decided to test it on my daily (2013 Accord Sport) before an appointment this weekend and I had some quirks.

Either VCM Scanner does not connect properly and cannot recognize the car at all then all I get is the WB readout on the channels list, or when I do get it to recognize the car the WB says it isn't connected when scanning starts.

Attached is the list when I get the vehicle to connect properly. All the normal PIDs are there except my AEM readout. Is this a vehicle specific issue?

Thanks in advance,

-John

[Binshou]

Now when I attempt to connect while I have the AEM pass-through connected, a loss of communication with instrument cluster code is thrown and at times the gauge cluster flat lines entirely. Without the-pass through I am able to connect normally without issue.

[dr.mike]

Try doing an info log to see what all is in there.