greetings tuners. i have a 2008 300c with a few mods. it was driven up to Orlando and is in limp mode and when scanned, no codes for transmission. a few codes for ecm but nothing to do with the trans, coolant fan speed 1 no response, 2 small evap leak codes. the positive was disconnected for 30 mins to reset the TCM,ECM but the codes did not clear in the ECM and still no codes in the TCM and still stuck in limp mode. the fluid level was checked and is higher than it should be, the fluid actually poured out from the overflow on the trans. the trans connector was checked and cleaned and still stuck in limp mode! any recommendations and any advice would be appreciated.