VCM scanner Blank parameters page(MPVI2)

[PurpleRam]

Last night I completed the "emissions" cert downloaded my code, resynced my MPVI2 , this morning I needed to add a table to a graph section, clicked on the "parameter" to add the parameter and I get a blank page ? resynced , redownloaded suite 5.04 hoping that would do something and Nope still nothing, is it a bug in the program, Or sis I screw it up somehow ?

[LilSick]

5.28.png

i am still on 5.1.888

did you try deleting one?

mighta maxed it out

[PurpleRam]

Did you try connecting to the vehicle and re-polling for supported parameters?

There is a reason I download new versions but don't install them for a while.

Yes, I tried with this truck, tried it on several different vehicles here at work re synced this mpv2 tried it all again, they all did the same thing.
I tried my work laptop with this same mpvi2 and it was fine, tried it again on the personal laptop and wouldn’t populate parameters,

Finally figured it out, I wrote a math parameter that I didn’t name, left the headline blank. Once I named it all parameters would populate
I did finally figure it out this morning