I read through the help file a few times and can't seem to figure this out, can someone help me out?
I am using the guide from the getting started section here, I went out for a scan run for about 30 minutes, before I turned the car off I stopped the scan and then saved data as. The LTFT hist was open since that is what I was logging for my part throttle tuning. When I open the log file nothing is in any of my histograms, the only place any data is saved is in the chart display. Am I saving the data wrong or is there a way to view the info in histogram format that I am just missing?
Thanks to anyone who can help me out. The scan file is attached along with the .bin file in case its needed.