-
Potential Tuner
V6 CASE Learn
Does anybody know the commands to perform one of these?
-
Senior Tuner
Here, this is better...
CASE Learn: To use the CASE learn function please follow these steps:
Put the vehicle into park (auto) or neutral (manual).
Turn off all accessories and A/C.
Apply the parking brake.
Press the brake pedal. Keep the brake pedal depressed during the entire procedure.
Press Begin.
Gradually rev the vehicle to fuel cutoff (around 4000-5000 RPM's) over a period of about 4 seconds. When fuel cuts out, immediately release the throttle.
Allow the engine to come back to an idle.
Turn the ignition off for at least 15 seconds. This step is required for the VCM to store the newly learned configuration.
Last edited by MMGT1; 02-22-2007 at 05:39 PM.
-
Potential Tuner
Thanks, but i'm looking for the commands that the TechII sends to the ECU to begine the CASE learn.