Results 1 to 5 of 5

Thread: 2016 GT throwing codes P064D and P064E

  1. #1
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    12

    2016 GT throwing codes P064D and P064E

    Just installed a Gen3R supercharger. Starts and runs on the VMP tune they sent but is throwing these 2 codes and running in open loop fault. Just replace both front o2 sensors this morning with not change. Anyone have any other thoughts other than bad ecu possibly?

  2. #2
    Advanced Tuner small tuner's Avatar
    Join Date
    Nov 2015
    Posts
    271
    inspect the o2 sensors extension if you have them, they could be the issue
    Turbocharged COYOTE

    PM for E tune / Remote Tuning
    [email protected]

  3. #3
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    12
    It's had extensions, I removed them and install new o2 ntk 27063 with no extensions. Still the same problem. Also resistance tested the wires and they where good.

  4. #4
    Senior Tuner veeefour's Avatar
    Join Date
    Oct 2016
    Location
    Poland
    Posts
    1,743
    This is heater code, so can be a fuse. Check power supply fuse for that circuit.

  5. #5
    Tuner in Training
    Join Date
    Oct 2015
    Posts
    12
    Check fuse and power supply. All where good.
    Got a new ecu and that fixed the issue.