-
Tuner in Training
2016 GT throwing codes P064D and P064E
Just installed a Gen3R supercharger. Starts and runs on the VMP tune they sent but is throwing these 2 codes and running in open loop fault. Just replace both front o2 sensors this morning with not change. Anyone have any other thoughts other than bad ecu possibly?
-
Advanced Tuner
inspect the o2 sensors extension if you have them, they could be the issue
-
Tuner in Training
It's had extensions, I removed them and install new o2 ntk 27063 with no extensions. Still the same problem. Also resistance tested the wires and they where good.
-
This is heater code, so can be a fuse. Check power supply fuse for that circuit.
-
Tuner in Training
Check fuse and power supply. All where good.
Got a new ecu and that fixed the issue.