Stock 5.3, On 3 76mm, deka 80s, 2 bar Cobalt map, 450 Walbro
I'm new to tuning, not looking for a handout.. just to be pointed in the right direction
The truck was starting and idling fine until I installed the injectors obviously.. I found a tune for a 03 Silverado on the sloppy wiki that is running deka 80s, a 6.0L, and an 80e with a 3 bar OS @ 14psi. I wrote this tune to my truck before noticing it was a 6.0L. I already swapped over all the info for a 4l60 before writing it, is it possible to just change the 6.0 to a 5.3 and cylinder volume number in the general tab and this tune run the truck enough to move around the shop?
He is running a 3 bar efi source map sensor and a 3 bar OS, can I calibrate my map settings to work up to 2 bar on a 3bar OS or do I absolutely need a 3 bar sensor?
I believe I attached a copy of the sloppy tune I'm referring to.. If i did that wrong let me know how to correct that
Any help would be greatly appreciated thanks!
-Nate