have drive mode reset to normal when ignition is cycled

[Ford385]

is it possible have the drive mode reset to normal when the ignition/key cycles. What I'm find is that if I engage tow/haul it stays active after the ignition has cycled off and back on.

I'm using a 2022 7.3 Godzilla with the 6R140 swapped into a '78 F250.

An indicator would also be nice - does anybody know if there PCM pin that energizes the tow/haul light?

[veeefour]

no, this is send via can bus to the cluster

[Ford385]

no, this is send via can bus to the cluster

thanks veeefour.

I also figured out the drive mode reset was not happening because I was using a latching instead of momentary switch. With the momentary switch, it resets to base/normal when key is cycled.

[veeefour]

thanks veeefour.

I also figured out the drive mode reset was not happening because I was using a latching instead of momentary switch. With the momentary switch, it resets to base/normal when key is cycled.

Looking at the schematics this might be case, schematic calls for momentary.