Can someone check their Prolink cable and the pinout is where it plugs into the MPVI3? Really just need AD 1, AD 2 and ground
PinOutMPVI3.png
1 top left
2 top right
3 bottom left
4 bottom right
5 outer ring
Can someone check their Prolink cable and the pinout is where it plugs into the MPVI3? Really just need AD 1, AD 2 and ground
PinOutMPVI3.png
1 top left
2 top right
3 bottom left
4 bottom right
5 outer ring
Does anyone have a prolink cable that they could Ohm out the red and blue wires to see which pin they touch?
It blows my mind this does not come with any info....trying to figure out how it gets wired in also.
Wasting time sifting through a damn forum instead of making progress on tuning the car.
You can find the pro link wiring information here
It doesn't have to be perfect, it just needs to be done in two weeks...
A wise man once said "google it"
To answer the original question; there is no direct connection between each end of the ProLink cable.
There is circuitry in the cable, which is converting the inputs in to a data stream for the MPVI3.
Because of this, you can not simply send a 0-5v signal in to the MPVI3. If you need analog inputs, you NEED the ProLink cable.
Reply With Quote