while data logging my tcc is very rarely applied usually its in slip or unlocked. the tcc locked is always set at no and tcc unlocked is sometimes set at yes but mostly set to no. any help to get my tcc to lock
??
while data logging my tcc is very rarely applied usually its in slip or unlocked. the tcc locked is always set at no and tcc unlocked is sometimes set at yes but mostly set to no. any help to get my tcc to lock
??
Robert Moreau
Technical Sales and Marketing Support Specialist
TransGo
2621 Merced Avenue El Monte, CA 91733 USA
Calibration | Innovation |Performance
https://transgo.com/our-products/
v14.hpl here you go
It is doing what it is asked to do, technically there is nothing to fix there. The Slip is never commanded to go to zero that's why the TCC unlocked PID reads NO. That's normal, but probably can be modified in the tune if you wanted it to fully lock. Unfortunately I don't know enough about that side to help. But right now, the transmsision in that log is operating as it should and like all those run with factory programing.
Robert Moreau
Technical Sales and Marketing Support Specialist
TransGo
2621 Merced Avenue El Monte, CA 91733 USA
Calibration | Innovation |Performance
https://transgo.com/our-products/